How to build the greenhouse

Growing vegetables in a greenhouse is not only easy to take care of, but also can be cultivated out of season. There are many advantages. How to build the greenhouse?

1. Simple greenhouse production

1. Material preparation

Measurement in advance requires building greenhouse specifications, bamboo wall thickness need to be prepared in advance of the bamboo, film selection of ordinary film, anti-fog film, multi-functional longevity film, etc., in addition to a diameter of 2-3cm length of 1m steel rod, hammer, No. 8 lead wire and other commonly used agricultural tools.

2. Location specification

The distance is usually measured with a tape measure, and the specific location is marked with lime according to the standard of 30m in length, 5m in width and 2.5m in height, and a small bamboo shed is built.

3. Planting and burying bamboo pole

Before planting and burying bamboo poles, according to the trend of the whole greenhouse, determine the specific location of each bamboo pole, probably put a bamboo pole every 60cm or so, keep the left and right sides symmetrical as far as possible to prevent the greenhouse from bending, and then use steel sticks to drill 50cm deep holes on the fixed point, when the soil is soft, you can play deeper in order to keep firm, and when other problems arise, you can also deepen appropriately according to the actual situation.

After drilling, insert the bamboo pole into the hole, then bend it to 2.5m, saw off the excess part of the bamboo pole directly, then fix it with No. 8 lead wire prepared in advance, and finally stick several straight bamboo poles at the top of the greenhouse to act as a supporting rod.

4. Cover the film

The construction of the bamboo greenhouse must be covered with film before it is completed. first of all, both sides of the greenhouse should dig a deep trench of 15cm, cover the film on the bamboo frame, spread the bottom along the bamboo frame in the dug deep ditch, and then suppress it with soil. If it is not trivial to break the film, it can be remedied with duct tape, and the left and right sides of the greenhouse will also be covered with the film above. You can plant several bamboo poles to leave a movable curtain as an entrance, and it can also be ventilated for crops.

2. Manufacture of steel frame greenhouse

The steel frame greenhouse construction method the steel frame greenhouse also completes the first basic preparation work, and then according to the installation process, the construction sequence is as follows:

1. First erect the rear wallboard.

2. Set aside expansion joints every 10m to form a wall.

3. Erect gables.

4. erect the shed skeleton, the distance between the skeleton is about 1m, first erect a pole on the inside of the gable at both ends, to ensure that the arc of the shed skeleton and the gable is consistent, and the line is erected from one end.

5. Tie rod connection.

6. Cover the back slope plate.

7. The embedded seam is waterproof and 10m is reserved for expansion joint.

8. Digging film trenches and burying anchors.

9. Cover greenhouse film, upper pressure film thread or pressure bar.