Techniques of Outdoor cutting of Flower Rose in Winter
1 treatment of flower cuttings
From the middle of October to the first ten days of November, the branches with symmetrical and hidden buds were selected according to the overwintering pruning of rose, the leaves were removed and cut into cuttings 10 cm long (about 3 nodes). The upper end was cut into a flat mouth, sealed with paint, and the lower end was cut into a slant.
2 preparation of flower nursery bed and nutrition bag
Choose a piece of land with leeward facing sun, flat terrain and loose soil to make a seedbed with a width of 1 meter, a length of 5-6 meters and a depth of 20-30 centimeters. Half-mix the mature nutrient soil and fine sand soil into soil moisture, disinfect it with zinc parathion and carbendazim and put it into a nutrition bag for spare; it can also be spread directly on the seedbed without a nutrition bag.
(3) Flower cutting
When inserting, put the nutrition bags on the seedling bed one by one. Pierce the hole with sticks or chopsticks, and then insert the insert, deep 1 move 2-2 stroke 3, compacted. Note: do not invert, prickle down, bud up, while inserting while watering, after insertion, pour water thoroughly. Then, stick on the seedbed, cover the film, and press it around with soil.
4. Management of flowers after planting.
4.1 if the weather is sunny and the temperature is high, the film at both ends of the seedbed should be opened at noon and ventilated. Otherwise, sunburn is easy to occur and a lot of people die at the beginning of spring. In the middle of November, seal the film.
4.2 after watering, removing the film and inserting it thoroughly, it will not be watered again. If the soil skin is white, you can sprinkle water properly.
A frozen layer is formed underground after winter, and the seedlings are not short of water. Observe the seedbed temperature when Rain Water and the Waking of Insects, and ventilate in time when it is higher than 20 ℃, otherwise it is easy to beaker seedlings. The film is gradually removed when the seedlings spread their leaves.
4.3 Insecticidal in late March to early April, insert buds of about 1 cm, easy to be attacked by aphids, should pay attention to prevention of aphids, can be fumigated with 80% dichlorvos, that is, 2 square meters to insert five cotton balls with medicine about 0.6 cm in diameter, removed in 2 hours. One week later, it was observed that if there were worms, they would be inserted again. At this time, special attention should be paid to insect pests, otherwise it will do great harm to seedlings.
5 points for attention
Winter rose cuttings, cold seedlings afraid of heat, can not be put into the greenhouse after spring. From April to May, pot or ground planting, normal maintenance.
Related
- What if the leaves of potted flowers turn yellow?
- Florescence Control of several Flowers
- Anti-freezing technology and post-freezing nursing technology of flowers
- What is the classification of flowers? What are the common methods of flower classification?
- Prevention and control of alkali and acid damage of flowers in courtyard
- Technology of Anti-freezing and restoring growth of Flower seedlings in greenhouse and greenhouse
- How does flower fertilization not hurt the root? Fertilization technology of flowers
- Key points of disinfection in flower greenhouse
- Several pesticides that are banned or used cautiously in flowers
- How to fertilize the flowers that watch the leaves?