MySheen

Illustration of the method of bud insertion propagation and seedling raising of rose

Published: 2024-11-22 Author: mysheen
Last Updated: 2024/11/22, The rose is strongly pruned before winter, and a large number of new buds sprout up and down the branches in the coming spring. In order to make the plant shape symmetrical, nutrition concentrated, and flowers rich, some of these new buds must be removed. These sparse spring buds are used as cutting materials with strong vitality and strong growth after survival, so it is a simple and easy method to raise seedlings.

The rose is strongly pruned before winter, and a large number of new buds sprout up and down the branches in the coming spring. In order to make the plant shape symmetrical, nutrition concentrated, and flowers rich, some of these new buds must be removed. These sparse spring buds are used as cutting materials with strong vitality and strong growth after survival, so it is a simple and easy method to raise seedlings.

First, pick buds

Northern time is in mid-March, potted rose to move out of the cold room or ground kiln, the ground rose also need to dig up the anti-freezing mound before winter. At this time, some of the buds of rose plants have already grown, and some have just sprouted. Under open-air maintenance, the germinated buds gradually turn red from yellowish green. When the new buds grow to 3Mel 7cm, they can be combined with fixed buds to shape and use the sparse buds as cutting materials. When picking buds, gently break them off, or cut them off with a blade from the base of the buds and close to the branches. The cuttings of these new buds can survive, but the new buds with stout growth, plump bud heads and sprouting at the base of the main branches are the best. The harvested buds can be washed with clean water before cutting, or dipped in 50% topiramate 1000 times diluent, and then cut.

Second, cuttage

Cultivated soil can be cultivated with plain sandy soil, interannual cultivated soil, peat soil, sandy soil and so on. Use basin, wooden box or slotting machine, pad a few centimeters at the bottom before cutting, cuttage depth is quite long bud 1AGU3 (2-3cm), after cutting, stick to the soil, pour water thoroughly, when there is no floating water on the surface of the sprout, cover with film to prevent air drying, the humidity in the cover should not be too high. In order to keep the soil moist, water should be properly watered, but do not accumulate water for a long time. The pot is placed close to direct light, and the humidity is kept between 10 and 20 degrees, which is not too high, otherwise it is easy to cause sprouting rot, generally, sprout and root after two weeks, remove the film after 20 days, direct light exercise, a month later, move to the outdoor shelter, and then put on the basin one after another.

The bud nodes at the base of the buds are overlapping and dense, so it is easy to divide new branches, and symmetrical and plump plants can grow within a year. This cutting method is simple and easy, and is most suitable for beginners with no cutting experience.

III. Steps

It is said that the survival rate of this method is very high, now the cuttings can be planted in the yard in summer, and it only takes a year to grow to 3-5 meters. The preparation material is very simple, peat soil or beautiful soil + perlite, the soil must be soft, breathable and moisturizing. Because the small buds are very tender, they will dry up immediately if they are not hydrated enough. As a matter of fact, I mainly push the beautiful soil! It is also good to take root very quickly.

Rattan moon buds are as small as possible. you can refer to the box below. After the soil is ready, spray water first to make sure there is enough moisture. The basin doesn't matter. I think the foam box is enough.

Remove all the leaves from the lower part of the prepared Fujiyue tender seedlings, as shown in the picture:

In the end, it becomes purple below ~ small light pole ~

The tender buds of rattan moon have weak resistance and are easy to be infected with fungi, so it is best to soak them with carbendazim and pick them up for a few seconds.

Finally, dig a small hole with tweezers and plant it one by one.

After all the plants have been planted, seal the surface of the flowerpot with disposable plastic wrap to keep the interior moist.

Then put it in a place with astigmatism or weak light, and you can check the roots after a week.

If you take root normally and then slowly move to a sunny place, gradually, you can transplant seedlings according to the situation a month later.

At present, I am not sure about the success rate, but many people have tested it with good results, so you can have a try.

Time: 2019-06-09 Click:

 
0