How do longevity flowers take root by hydroponic culture

Longevity flower cutting is very simple, flower friends only need to look at the picture to learn, this article is a flower friend from longevity after pruning, to branch treatment, cutting treatment process, basically includes a variety of longevity flower cutting methods.

Water culture of longevity flowers can be divided into two cases, one is water insertion and rooting, and then soil cultivation, and the other is as hydroponic plants, always hydroponic culture, let's sort out these two kinds.

1, water rooting: this is relatively simple, casually get a branch, and then insert into the water can be used in less than a few days to produce white roots, if you want to transplant, it is best to dry some of the roots before planting, but water rooting and transplanting is a bit superfluous, because longevity flower cuttings are very simple, and the survival rate is also very high.

2. Hydroponic longevity flowers: this is also very simple. Choose the branches that look good in the plant type, and then insert the hydroponic bottle. Generally, change the water once a week and rinse the roots (of course, it is also possible to continue the water). Some flower friends question it. Is it as simple as that? It is really that simple, longevity flowers are very easy to manage flowers and plants, as for the later water culture bottle whether to put some ceramsite ah what, it all depends on the individual play!

Methods / steps of cuttage hydroponic propagation of longevity flowers:

1. Prepare the cuttings-the mother plant after cutting off the branches. We can see that new branches begin to emerge on both sides of the branches, so flower friends should remember that if you cut the branches yourself, you should cut them about 1 cm above the axillary buds, which will help the mother plant to branch and air-dry the cuts for one night or one day.

2. We should treat the cut branches properly and then cut them. Wash and disinfect the seedling box, fill it with 8 minutes, drill a good hole in the sterilized foam, open a little rooting powder with 2 drops of alcohol (because the rooting powder is not soluble in water), dip the end of the insertion rod in the rooting powder, then insert the Jack and fix it, all the leaves should be above the foam.

3. Find another branch to demonstrate, we can see that we can cut several small segments of a branch, so that each section will become a new longevity flower, each segment should retain at least two nodes with leaves, and then break off the leaves of the bottom node. Remember to make a good label, light, flat into the seedling box.

4. If it is winter, the cuttage can be covered with a transparent seedling box cover, which is not needed in summer and autumn, then move the seedling box to the bright place and wait for it to take root.

With regard to the use of water in hydroponics, it can be natural water, preferably natural water or mineral water for 1-2 days, the water had better immerse the roots of 1PUBG 3, and then put it in a ventilated and cool place to avoid direct sunlight.

Of course, for hydroponic longevity flowers, there are flower friends who ask if they need to put nutrient solution? In fact, a certain amount of nutrient solution can be added appropriately, and some flower friends report that putting too much nutrient solution will easily lead to rotting roots. You can give it a try.

Time: 2019-06-09 Click: