How to plant the seeds of the rich tree

The ornamental value and practical value of potted rich trees are obvious to all. Not only can large potted plants be placed in the courtyard or used in commercial occasions, but also small potted plants can be planted to decorate the home environment, often with good results. And there are many propagation methods of rich trees, which can not only be sown and propagated, but also can be cultivated by cutting, and can also be improved by grafting. In contrast, sowing and reproduction has the advantage of large seedling emergence, which is of great significance for mass production. So, how to plant the seeds of the rich tree?

The sowing and propagation of rich tree is a very common way to breed seedlings, whether it is batch production or family breeding of potted seedlings, it is often more suitable. And the seedlings bred by sowing are often straight-rooted and smooth, and it is also very easy to develop a thick "radish shape" at the lower end as a family pot plant, which is very important for pot modeling and improving the ornamental value of pot plants.

The sowing and propagation of the rich tree can usually be carried out in the four seasons, as long as the temperature conditions can be satisfied. However, generally sowing in spring has a higher seedling emergence rate, although the rich tree grows relatively slowly, it is easy to shape after the tree is grown, and it has a certain advantage in making bonsai. Next, the editor will share with you the methods and steps of using seed sowing to make a fortune tree.

1. Harvest the ripe fruit from the mother tree of the rich tree, and then knock open the hard shell of the fruit and take out the seeds hidden in the shell and set aside.

2. Prepare a shallow basin and plain sand, and then load an appropriate amount of plain sand into the basin. The shelled rich tree seeds prepared in advance are sown shallowly according to the plant-row spacing of 5-10 cm, and the sowing depth is 3-4 cm.

3. After sowing the seeds into the soil, we need to replenish the seeds in time to keep them moist. Generally, there is no need for direct watering, because it is not easy to control the amount of water, it is easy to wash the seeds out of the soil, and the water distribution is difficult to achieve a uniform state. Therefore, we mostly use the immersion basin method to replenish the permeable water.

4. During sowing and breeding, we should pay attention to control the temperature, generally keep the ambient temperature between 25-30 ℃, and do a good job of replenishing water and keeping moisture at the same time. If it goes well, it will take about 7-10 days to wait for the seeds of the rich tree to sprout. When the seedlings pull out 3-5 leaves, we can transplant them into the ornamental pot for maintenance and management.

It is worth noting that the rich tree is a polyembryonic plant, generally each seed can grow 1-4 seedlings, so the reproduction coefficient is very large, as long as the growth environment is suitable, the yield of seedlings is also very high. The above is the method of sowing and breeding seedlings of rich trees. I hope you can understand this.

Time: 2019-06-06 Click: