The steps of making moss bonsai

Nowadays, moss bonsai has been well cultivated, as a very special plant, its survival rate is high and many other characteristics, but during the cultivation period, special attention should be paid to the invasion of other higher plants, so no matter how, the cultivation process of moss bonsai plants is also the most critical. How about, have seen moss bonsai pictures, is there some heart? So do not prevent the use of moss planting methods, to raise a pot of moss bonsai to decorate their own beautiful home!

Making bonsai moss is a good choice, but many friends have only seen bonsai moss in the exhibition hall or pictures, and they only know a little about the actual operation. Well, if you want to make it, don't worry, let the helpful author teach you:

I. Preparations.

1. Look for moss. There are many kinds of moss suitable for decorating potted plants, but the most important thing is that Tess is not too long. There are also many channels to obtain moss. Some friends buy it online, which means they are too rich. I calculated that the general 30cm basin surface will cost nearly 50 yuan. If you have hobbies and love, isn't it better to donate 50 yuan to Hope Project?

Our common people's practice is to find suitable plants on the shady ground, stones or tree trunks in the mountains.

Of course, if you are a large and medium-sized city, it is difficult to do, then your easiest way is to go to some years of brick-concrete roof solar panels below, next to the drainage holes, tile surface of tile houses, outdoor drainage to find. A few days ago, my father-in-law's solar energy did not enter the water. My wife asked me to go up to the roof to have a look. I went quite lazily. Unexpectedly, I found:

2. Collect moss. Gently scrape the whole piece along the bottom with a blade or bamboo stick.

3. Prepare some fine soil, which should be sticky, and remove large particles.

4. Prepare bonsai. You don't have to prepare it, just bring it and set it up. This is a rose.

5. Clean up the basin surface. Use a knife or bamboo stick to hang off the rough layer of the basin surface.

6. Prepare a basin of water and a cup. No towels, which means it's not for cleaning your hands after you're done. You'll know what it's for.

II. Formal opening.

1. Clean up moss. Clean up the moss base, the larger, faster, wood debris, rotten leaves.

2. Prepare the basin surface. After the potted plant is watered thoroughly, a layer of fine soil is evenly sprinkled on the surface of the pot, generally not exceeding 1cm (more than 15 cm is not moss), and then the fine soil is watered and gently stirred into a thin mud.

3. Spread moss. The shape of each piece of moss You can gently tear off the corners according to the shape of the basin surface and the pattern you want to arrange. You can also use scissors. Be careful not to cut your own.

The first piece was laid:

Cut out the corner material to fill the unfinished space. To make full use of resources oh, waste is shameful drops! Especially common people like you and me!

4. Fully bonded. To get moss to stick tightly around a potted plant with soil at its core,

Pour water on the moss, not too much. Pat it gently with the palm of your hand until it's firm, and some mud comes out of the basin.

III. Cleaning

1. Clean bonsai.

The basin won't move itself, so turn it upside down yourself, sprinkle water from the top side, rinse off the mud, and then clean the outer edge of the basin.

Well, isn't it cleaner and prettier?

2) Management in the future. Put the prepared bonsai moss in the shade of the courtyard or in a cool and ventilated place at home. Spray water with a watering can every 1-2 days to keep the moss moist, and slowly the moss will survive.

IV. There will be results

Below are some bonsai moss I used to do well, ugly, terrible, bold at will to see it!

Made half a month ago, the material is taken from the roof insulation layer, the material is good, no wonder it can be insulated:

Made a month ago, the materials were taken from the ditch of relatives in rural areas. At a glance, it was ecological and there was no urban pollution.

It was made three months ago, and the material was taken from the ground by the wayside. Tess was too short, thin and short for reality. It looked pitiful, but it would grow

This is the seed of moss (spore), let you know.

Time: 2019-05-26 Click: