Cutting techniques of Sabina vulgaris bonsai
Ground cypress, also known as cypress, climbing cypress. Belongs to the cypress family, the genus Sabina. Evergrape shrubs. Because of its twisted dry diameter, fine branches and strong adaptability. Easy to shape and other features are loved by the majority of bonsai lovers. Cuttage propagation of Sabina vulgaris is a cost-effective way of propagation, so it is often used. The bonsai production of cypress is relatively simple. Let's learn it together.
In the middle and last ten days of July, the cuttings of the same year were selected as cuttings, which were 10-15 cm long, and all the needles at the base of 2-3 cm were removed. Cut a new stubble from the base of the cuttings with a blade, quickly dip it in 500ppm naphthalene acetic acid solution, and then cut it on the sand bed. The density is 6 × 6 cm and the depth is 3 cm.
After plugging in, use No. 8 lead wire or steel bar to support an arch every 40 centimeters across the bed, the vault is about 50 centimeters away from the bed, covered with plastic film and pressed with bricks. A spraying device is installed in the shed, and a Reed curtain is covered on the shed to shade; the temperature in the shed should be kept below 35 ℃, and water should be sprayed to cool down when it exceeds 35 ℃. The relative humidity of the air in the shed should be more than 85%, and the moisture should be replenished in time when it is low. The cuttings began to take root in 30-40 days, and the general survival rate was more than 95%.
Dig a hole of 40 cm × 40 cm × 50 cm before planting, put the seedlings into the hole, fill the soil to 2 / 3, gently lift the seedlings, then step on them with your feet, fill the soil until the pit is full, step on it again, pour it thoroughly, and after 6-10 days, pour water again and seal the pit. The survival rate is more than 90%.
Time: 2019-05-23 Click:
- Prev
How to prepare the cultivation substrate of Anthurium andraeanum bonsai
The family potted Anthurium andraeanum can be mixed with peat soil, perlite and bone powder, and the basin bottom should be covered with coarse sand to facilitate drainage. Before the Anthurium andraeanum is put on the pot, the soil matrix needs to be disinfected. The Anthurium andraeanum plant is placed in the center of the basin, filling the culture soil to the basin surface, and pay attention to exposing the growth point of the plant center and the basal leaflets.
- Next
Pots Selection and Upper Pots of Chinese Cupressus Bonsai
The ground is covered with green cypress branches and leaves, winding and creeping, and suitable for viewing in all seasons. The best viewing effect is when the new branches and leaves sprout in spring. It is not advisable to keep it indoors for a long time during the growth period. The cypress is easy to shape and can be made into a horizontal symmetrical bonsai, which can be placed in the courtyard or reception room for appreciation.
Related
- Fuxing push coffee new agricultural production and marketing class: lack of small-scale processing plants
- Jujube rice field leisure farm deep ploughing Yilan for five years to create a space for organic food and play
- Nongyu Farm-A trial of organic papaya for brave women with advanced technology
- Four points for attention in the prevention and control of diseases and insect pests of edible fungi
- How to add nutrient solution to Edible Fungi
- Is there any good way to control edible fungus mites?
- Open Inoculation Technology of Edible Fungi
- Is there any clever way to use fertilizer for edible fungus in winter?
- What agents are used to kill the pathogens of edible fungi in the mushroom shed?
- Rapid drying of Edible Fungi