What about the rotten roots of the iron tree?

What about the rotten roots of the iron tree? After 2 months of planting, the bare-root iron tree has withered leaves and rotten roots, and the rotten roots are mainly caused by the following reasons.

First, because the iron tree naked root, from the south to the north, without the necessary wind and cold protection measures, because its root system is seriously damaged and can no longer provide water for the plant, usually the leaves turn brown and then die.

Second, because the root system is blown by the wind or frozen later, it is bent repeatedly during transportation, which will inevitably cause it to lose its function of absorbing water and nutrients. If it is planted in a pot, it does not cut off some leaves in time and does not cut off the lifeless root system. It may be planted with fertile humus culture soil, coupled with too much watering, or even fertilizing before its absorption function is restored. In this way, due to the poor permeability of basin soil and the enrichment of water and nutrients, the root system will inevitably rot.

For the iron tree with withered leaves and rotten roots, can it be "dead" and resurrected? In fact, this kind of death is a "fake death", and its vitality is extremely strong, as long as its stem is not soft by freezing or water seepage and rot, it can be revived by exercising special rescue measures to make it "dead". The specific measures to rescue the rotten roots of the iron tree are as follows:

First, the leaves of the plant are cut off from the base, and then the rotten roots are trimmed clean. the root clips can be treated with sulfur powder and clean charcoal powder, then put them in a warm and ventilated place to dry, re-select clean flowerpots, plant roots with moist and clean river sand, and the water content of sand should be held by hand and loosened. Be careful not to bury all the stems of the iron tree in the sand, only 3 to 5 centimeters above the root neck.

Put it in a warm room to keep the sand moist and let it survive the winter safely. After Grain Rain next spring, he moved it outside and buckled it on the plant with a tile basin without a drain hole, creating a dark environment to induce new leaves. As long as the stem is not rotten iron tree, generally to May-June, can re-sprout roots, while the emergence of new leaves.

When the iron tree leaves about 10 cm long, should uncover the buckle basin, put it in a better light position, but at this time must not be exposed to the sun, so as not to burn the tender leaves. At the same time, pay attention to the control of moisture, so that the leaves will not be too thin and too long. After the leaf growth is stable, it will be re-cultivated in fertile soil and given normal water and fertilizer management. the above is the introduction of how to do the rotten roots of the iron tree.

What about the rotten roots of the iron tree? when the iron tree is cultivated, it is often caused by soil hardening, excessive fertilization, too much watering, etc., resulting in withered leaves and rotten roots. If it is not rescued in time, the whole plant will die. Rescue measures: knock the iron tree out of the flowerpot and cut off the dead leaves and rotten roots. the roots were soaked in 800-1000 times chlorothalonil or thiophanate for half an hour to be sterilized and dried to be put on the pot. On the pot, you should choose a clean flowerpot, plant it with germ-free sand, water it once, and then place it in a cool and ventilated place where Rain Water can't catch water. Often pay attention to watering and heat preservation, so as to restore its vitality, in order to take root and send leaves in the early summer of next year. For the iron tree with withered leaves and little damage to the stem, after cutting off the withered leaves, replace the new culture soil, pay attention to watering to keep the soil moist, and put it in a semi-shady place to manage. Treatment of rotten roots of iron tree

Cycad, commonly known as iron tree, is an excellent foliage plant loved by people. Due to soil consolidation, excessive fertilization, abnormal watering and other reasons, it is often easy to cause leaf whitening and wilting, root rot, if not timely treatment, the whole plant will die. To rescue the iron tree with rotten roots, it is necessary to change the soil into sand so as to facilitate the re-emergence of new roots. Pull the iron tree out of the flowerpot, cut off the dead leaves and rotten roots, re-choose a clean flowerpot, then pad the tile, plant it with bacteria-free plain sand, and water it once, and then put it in a cool and ventilated place that Rain Water can't drench, often pay attention to watering and moisturizing, restore vitality, and create conditions for rooting and sending leaves in early summer next year. For the iron tree with withered leaves and little damage to the stem, after cutting off the withered leaves, replace the new flower mud, pay attention to watering to keep the soil moist, and put it in a semi-shady place to manage.