How to reproduce jasmine

Jasmine is easy to reproduce, generally using cuttage propagation, using old wood and tender wood cuttings. As long as the branches with strong tissue, thick green leaves and no diseases and insect pests are selected as cuttings, cutting is feasible at any time under the condition of air temperature above 20 ℃. April to June is the most suitable, May to June cutting, the same year will blossom; July cutting, can only grow new shoots, can not blossom in the same year. Although it can be cut after autumn flowers, it will only heal, it is not easy to sprout new roots, and it will not be able to shoot roots until it comes out of the house the following year. The pruned branches after leaving the house in spring can be used as cuttings, and there are also steep long branches or hidden branches cut off after each flowering as cuttings.

Prepare flowerpots before cutting, either with mud pots or home-made wooden boxes. The drainage hole at the bottom of the basin pads the broken basin to be suitable for drainage and aeration, then mix the sifted garden soil or rotten leaf soil with 1xanthium bran ash and put it into the flowerpot about 8% full. The cuttings are about 10 cm long and have 2-3 nodes per panicle. Leave a pair of leaves at the upper end of the cuttings or cut off half of the leaves, and cut off all the leaves at the bottom. The incision should be close to the section, the lower incision is about one centimeter below the section, and the upper incision is about one centimeter above the section. The upper incision should be cut into a bevel to prevent stagnant water from rotting.

When cutting, first use bamboo chopsticks cuttings, insert the depth of cuttings length of 1 beat 3 or 1 hand 2, use your fingers to press the surrounding topsoil, so that the cuttings and basin soil close. After insertion, spray water with a fine hole spray can, water thoroughly, put it in a shaded place with the leeward, avoid sunlight during the day, and leave it outside in the evening, so that the cuttings can be moisturized with dew. You need to use plastic sheeting to protect against rain on rainy days, or move the fertilizer basin indoors. After insertion, you should pay attention to watering, but not too wet, as long as you keep the basin soil moist. It usually takes 20 to 30 days to take root. After growing tender shoots, you can apply some light fertilizer and water once every other week. If it is cut from May to June, it can be planted separately in July, and a small amount of flowers will bloom in August. It is not usually planted in pots until the following spring.

Some plants can be propagated by striping. Every year before the Summer Solstice. Select current-year-old or 2-year-old branches, about 45cm to 60cm long, press down at 15cm from the mother plant and press into another basin. There must be a section in the pressure soil, and it must be cut under the section before it is easy to take root. Cover soil 10 cm, after 40 days can be cut off from the mother. It will be correct after another 10 days. It is expected to blossom at that time.

How do potted jasmine flowers propagate? Breeding skills of potted jasmine!

It is understood that jasmine is a very fragrant flower, which is a famous raw material for scented tea and an important raw material for flavor. Its beautiful flowers are white, and its pages are evergreen all the year round. It is a kind of potted flowers very suitable for courtyard planting. Today, Huinong Network will teach you the breeding method of potted jasmine flowers. Flower lovers take a look!

The propagation of jasmine mainly includes cuttings, striping, plantlets and so on. Among them, cutting is the main one.

(1) Cuttage:

It can be carried out in spring, summer and autumn, and the survival rate is the lowest in summer. Select one-year-old stout and full branches in early summer, cut them into about 15 cm long, and keep 3-4 nodes. Cut off the leaves at the bottom of the cuttings, leaving only the top 2-3 leaves. Insert 1-2 sections of the lower part of the cuttings into pure plain sand or vermiculite, then pour water thoroughly, cover with glass or plastic film, and place in shade. Generally, when the soil temperature is about 20 ℃, the cuttings can take root in 30-35 days. The temperature and humidity are high in July, and the cuttings can take root in 20-30 days.

(2) crimping:

Generally from May to June, the 2012 sturdy branches with a length of 30cm to 35cm are selected, cut at 15cm to 20cm, and then buried in the soil. It begins to take root after about 20-30 days, and can be cut off after 50 days to become a new plant.

(3) ramet:

It can be combined with changing pots in spring. In general, 3-year-old plants can be divided into 2-3 clumps, each about 3-5 culms. When ramet, remove the soil from the rhizosphere, carefully separate the crossed roots, and then cut off the connected roots with a sharp knife and pot them immediately according to the needs of the ramet. All the leaves of the new plants should be removed, watered thoroughly, properly shaded, and moved to the sunny place after the new buds sprout for normal management.

The above are the breeding skills of potted jasmine, the method is simple and easy to live, flower lovers hurry to have a look!

How to reproduce jasmine, the method of propagation of jasmine

Jasmine is commonly propagated by cuttage, ramet and striping. Today we will introduce how to reproduce jasmine and how to reproduce jasmine.

The method of propagation of jasmine:

The main results are as follows: 1. Cutting propagation is the most commonly used propagation method of jasmine. The mixed substrate of sand or sand and mud can be used from April to October, and the plum rain season is the most suitable, so the warm and humid time is good for rooting. Select mature and strong one-year-old branches, about 10 cm long with 3 or 4 nodes, leave a pair of complete leaves at the top, and remove the rest. First, the hole was inserted with a bamboo stick, and the depth of the cuttings was 2. 3, then watered, moisturized and shaded to maintain high air humidity, new roots grew in about 20 days, branches and leaves came out after 50 days, and could be transplanted after 2 months.

Jasmine can also be inserted with water and take root in 10 to 15 days, which is suitable for families to plant in small quantities. It can be from April to October, and the optimum period is before the spring temperature rises and the branches sprout.

You can choose strong biennial branches with full bud eyes, about 15 cm long with 4-6 axillary buds and 2-3 leaves at the top.

Choose glass parallel or other containers, opaque is the best, conducive to root. Fill the bottle with cold boiled water, wash the cuttings and insert them into the bottle. Soak the cuttings in water about 2GP3. The mouth of the bottle is stuck with skimmed cotton, so that the cuttings are suspended in the bottle without touching the bottom of the bottle. In the back shade, keep the temperature above 20 ℃, avoid direct sunlight, and change cold boiled water once every 2-3 days. It can take root under the festival after 10-15 days.

2. striping propagation of jasmine flowers is mostly carried out in the growing period. the branches near the ground are taken as strips, peeled or scratched where they need to take root, then pressed and fixed in the soil, the soil is compacted, and the top of the branches is exposed to the soil to moisturize. After 5 months, the mother plant can be cut off and planted separately.

3. The regeneration ability of ramet jasmine is strong, and adventitious buds often occur in the roots, forming new branches, which can be used for ramet propagation, usually in combination with transplanting and changing pots in spring or autumn. Select the plant with many prosperous branches, pull up the whole plant and split it with a sharp knife, and use the small plant with roots for planting. Generally speaking, you can only separate 2-3 plants from the mother plant at a time, or dig up the soil around the mother plant and cut off the sub-plant. Ramet propagation requires that the amount of roots should be commensurate with the plant, too many branches and leaves should be trimmed part of the branches and leaves to ensure survival, shade and heat preservation after planting.

How to reproduce jasmine, the propagation method of jasmine is introduced here. I believe everyone knows how to reproduce jasmine and how to reproduce jasmine. I hope the introduction of Xiaobian can help you.