Propagation method of Happy Tree with good Environment, good feng shui and good intention

The scientific name "Happiness Tree" is Bean Tree, which enjoys a hot, humid and sunny environment. Resistant to high temperature, afraid of cold, should be moist, avoid drying. It is a very good foliage and flowering plant, and the moral is good, so many people choose to plant in the courtyard or potted plants in the living room and other places, so how to plant happiness trees? Next, the editor will take you to learn about the breeding method of the happiness tree.

The breeding method of happiness tree:

1. The method of striping and breeding of Happiness Tree:

From March to April, circular peeling can be carried out under the nodes of 2-year-old strong branches or stems, and the peeling width is generally 2 to 3 times the diameter of the pressed stem. Under the ring peeling mouth, tie up a piece of plastic film of 15 cm × 20 m. Using clean, moist peat or sandy loam, squeeze a lump of soil with a diameter of 8 to 10 meters at the ring. Then, wrap the soil mass with plastic film, leave a good water port at the upper end, and tie it against the thick trunk to prevent the droop from being broken by the wind. At the end of autumn, after the ring peeling mouth grew a better root system, it was cut off from the mother plant and planted in a pot.

2. The method of planting and breeding in the tree of happiness:

Cuttage propagation is usually carried out from March to April. When the ambient temperature is about 15 ℃, 1-2-year-old lignified branches are cut, about 15 to 20 centimeters long, all leaves are deleted, and the lower incision is preferably located at 0.5 centimeters below the node. The cuttings are inserted on the sandy soil seedling bed, and the depth of cuttings is about 1 / 3 to 1 inch 2 of the ear length. During the period of undercutting, healing and rooting, water should be sprayed to keep the seedbed moist. After its intact root system, it can be transplanted with soil mass into the pot, preferably 2 to 3 plants co-planted, which can be formed and sold as soon as possible.

3. The method of sowing and breeding of happiness tree:

Sowing and reproduction is usually at the end of December, when the capsule is close to cracking and the seeds are fully mature, the long striped capsule is harvested, dried, the winged seeds are removed, rubbed, the membranous seed wing fragments are removed, and the seeds are dried and stored for sowing next spring. It can also be soaked for 2 to 3 hours and then mixed in wet sand, spread thinly in a large plastic basin in the shed, keep the seed and sand moist, often check to prevent mildew, and then sow seeds after seed germination. The dried seeds were soaked for 3 to 4 hours from March to April, then mixed with sand and sprinkled on the seedbed, lightly covered with thin soil and covered with film to moisturize. After the seeds emerged, the film was removed and shaded. When it grows 2 to 3 true leaves, it can be transplanted with soil mass, or when it grows 4 to 5 large leaves, it can be planted in pot or bag.

Happiness tree is a plant that many people like, with beautiful flowers, long flowering period, elegant tree posture and beautiful meaning. It is appropriate to use loam and sandy loam with loose and fertile soil, good drainage, rich organic matter and sandy loam. Planting at home can not only beautify the home, but also have a better fengshui idea.