Two methods of propagation of money tree

Money tree because of its beautiful name, many people will buy a pot of money tree and put it at home to make a fortune. The money tree has been raised for a long time, it must need to breed. In order to ensure that the money tree can reproduce smoothly, most people will know to pay attention to good methods. This paper introduces the breeding method of money tree.

Ramet propagation

In April, when the outdoor temperature was more than 18 ℃, take off the large plant, shake off most of the persistent soil, break it from the weak combination of tubers, and spread sulfur powder or plant ash on the wound, and plant it in another pot. Be careful not to bury it too deep when planting, just bury the top of its tuber under the soil for 1.5~2cm.

In addition, according to the characteristics of latent buds on the tubers, a large single tuber can be divided into small pieces with 2 or 3 latent buds, and after the wound is drier, it is first buried in slightly moist fine sand, and then planted in a pot after the small tubers to be cut grow into independent plants.

Cuttage propagation

Cuttings can use a single leaflet, a leaf axis plus 2 leaves or a single leaf axis. In terms of rooting effect, the cuttings with leaves on the leaf axis had faster rooting speed and higher germination rate, and it was easier to open into larger tubers. After inserting a single leaf into the mixed medium mixed with river sand and vermiculite, a rooting bulb can be formed at the base of the leaf after 10-14 days, and it can grow into a small plant after 2-3 months of cultivation, but the seedling rate is not high in general.

If the leaf axis or leaves with leaves are used as cuttings for cuttings, the substrate can be made of general fine sand, or peat soil, perlite and river sand can be mixed at the ratio of 3:1:1 to prepare the substrate. The cuttings are buried at the depth of 1pm, leaving only the leaves outside the substrate, sprayed in a shaded place after spraying water, maintaining the ambient temperature of 25 ℃ ~ 27 ℃, and spraying the leaves once or twice a day depending on the dryness and humidity of the substrate. Keep the substrate slightly moist and must not be too wet, otherwise it will cause cuttings to rot and lead to cuttings failure.

When the cuttings form a certain root system, the middle of the root gradually expands to form a spherical tuber, and the tuber increases gradually. some of the young cuttings will wither and die because of high temperature or poor water management, but the tuber can survive. Old mature leaves and cuttings with total petioles can also maintain green and vitality. A small number of tubers can sprout and grow new leaves in the same year, but the growth is weak and slow, and the tubers grow sturdy new buds and grow normally the next year.

The knowledge about the breeding method of the money tree is introduced here for the big family first. If you are raising a money tree, you also need to know its daily management methods, fertilizing, watering, and so on, so as to ensure that the money tree will be raised better and will not wither.