MySheen

Introduction to the propagation methods of rubber trees

Published: 2024-11-24 Author: mysheen
Last Updated: 2024/11/24, Introduction to the propagation methods of rubber trees

The rubber tree has high ornamental value and is a famous potted foliage plant, which is very suitable for indoor beautification. Small and medium-sized plants are often used to beautify the living room and study; medium and large plants are suitable for being arranged on both sides of the foyer of large buildings and in the center of the lobby. It is magnificent and magnificent, which can reflect the tropical scenery, and rubber trees are commonly used in two breeding methods: cutting and high pressure.

Planting and breeding is relatively simple, easy to survive and grow fast. It is generally carried out in late spring and early summer combined with pruning. Select the annual Lignified middle branch as cuttings, cut off the lower leaf, close the upper two leaves and tie them with plastic, or cut off the upper half of the leaves to reduce water evaporation; in order to prevent the loss of too much milk from the cutting mouth and affect survival, the wound should be smeared with plant ash in time; the treated cuttings should be inserted into a bed based on river sand or vermiculite. Keep the plug-in bed with high humidity after insertion, and often sprinkle water to the ground (but not stagnant water) to improve air humidity. Under the condition of 18-25 ℃ and semi-overcast, it can take root after about 2-3 weeks.

It is also convenient to use high pressure in the family, and the success rate is also high. Select biennial branches under high pressure, first peel 1-1.5 cm wide on the branches, then wrap them around the wound with wet moss or peat soil, and finally wrap them with plastic film, and bind the upper and lower ends; after 1-2 months, the rooting branches can be cut off and put on the basin.

The above is the editor to introduce you to the breeding methods of rubber trees, I hope to be helpful to you!

 
0