Tiger skin orchid breeding method scissors should be sterilized
The survival rate of Tiger Pilan is very high. As long as there is one plant at home, it can quickly fill the whole family. How do you do that? Take a direct look at the breeding methods of Tiger Pilan, and you will be attracted by this exuberant vitality:
The first step: first, cut a long and wide mature leaf from a strong pot of tiger skin orchid and cut it off from the bottom of the leaf. (you can use a knife or scissors, but it must be sharp, do a good job of disinfection and soak in boiling water.)
The second step: cut the tiger skin orchid leaves into several segments, each of which is about 5 to 10 centimeters in length, with an approximate length, and there is no need to measure it. (the cuts are all cut from the bottom up, because they take root.)
Step 3: dry the cut tiger skin orchid leaves for a little bit for an hour, dipping it with rooting powder is better!
The cuttings are cut in the soil. (the soil of the cuttings should be loose and well drained.) A potted friend asked: which end is cut into the soil?
The downward part, of course, otherwise you can still land on your head.
Finally, it is time to wait for the end, put the cultivated flowerpot in a bright scattered light, ventilated environment, maintain a slightly moist state, give it appropriate water!
It will sprout in about 3 or 4 weeks! It takes a lot of patience. Can you do it?
Tip: after cutting, it is easier to sprout with a film cover on the flowerpot cover, but to be ventilated for three hours a day, lazy people can poke more holes in the film. Can achieve the effect of heat preservation and moisturizing!
The breeding method of tiger skin orchid is introduced here, let your home grow a few more plants as soon as possible.
Culture methods and matters needing attention of hydroponic tiger skin orchid
Tiger skin orchid, also known as tiger tail orchid, is not only an ornamental plant, but also can absorb indoor harmful substances, such as formaldehyde, so many families will choose to buy tiger skin orchid after new house decoration. At the same time, for convenience and environmental considerations, they will also use hydroponics. So what are the breeding methods and matters needing attention of hydroponic tiger skin orchid?
Culture methods and matters needing attention of hydroponic tiger skin orchid
Before hydroponic tiger skin orchid, the roots should be washed and subtracted by 1/3 and then hydroponically cultured, which can promote the growth of new roots.
Whether it is hydroponic tiger skin orchid, or other plants, the problems that should be paid attention to when cultivating are the same, which can be divided into the following aspects:
Temperature: the hydroponic tiger skin orchid has a good ability to adapt to the temperature, it can grow well if it is handled properly indoors, and it can be full of green even on the same day.
Lighting: Tiger skin orchid is a sunny plant, but it can not be exposed outdoors for a long time. If you cultivate hydroponic tiger skin orchid outdoors, remember to take corresponding shading measures; if you are indoors, just let your plants bask in the sun occasionally.
Nutrient solution: sometimes in order to plant better growth, many people will buy nutrient solution, there is also a special hydroponic nutrient solution to sell, you can mix their own concentration. Note that when the water culture tiger skin orchid, when the indoor temperature is too low, the plant is difficult to survive, at this time to pour out the nutrient solution, let the tiger skin orchid into hibernation.
Changing water: this is the most important part of the whole hydroponics link, and it is also the most tedious operation. In the initial stage of hydroponic culture, the deterioration of water quality may lead to rotting roots, and if the water is not changed all the time, it may lead to plant death. There is also a quick way to judge rotten roots, that is, through the water quality, you can smell the smell. Therefore, in order to ensure the oxygen supply in the water and let the tiger skin orchid grow healthily, the water should be changed frequently. In general, the water can be changed every 5-10 days and 5 days in summer. At the same time, remember to clean the plants when changing water. Is to use sterilized scissors to cut off rotten roots and old roots, so that new roots can grow better, and then be careful not to cut to water roots.
The above are the breeding methods and points for attention of hydroponic tiger skin orchid. I hope it will be helpful to those in need.
Cutting methods of Cymbidium
The cuttage propagation of Cymbidium is our most commonly used method of propagation, and it is also the fastest method. 1. Choose a healthy tiger skin orchid, cut a leaf with sterilized scissors, break off 2 leaves, cut one into 3 pieces, you can cut more at a time, each section is not less than 6 centimeters, remember that scissors must be sterilized. 2. Leave the cut leaves in a cool place for 6-8 hours to see if the cut has dried. 3. Prepare clean sand, pour water thoroughly, and insert tiger tail orchid into 4cm or so.
4. Choose semi-humid soil, then insert the leaves and place them in a cool place. Remember not to water the roots within 5 days, otherwise they are easy to rot. Water them normally after 5 days to ensure that the soil is moist. Put the tiger tail orchid in a ventilated position, do not bask in the sun or get caught in the rain for the time being. Spray water every day to keep it slightly moist. 6. Cymbidium cuttings rooting is a long process, and it takes a month to take root (May-June is usually shorter), so we need to wait patiently. A month or so after taking root, a lot of small buds will emerge and seedlings will gradually grow. 7. When the tiger tail orchid grows up, it can be transplanted.
Warm reminder:
1. To be patient, it takes about a month for Cymbidium cuttings to be cut, during which time there is no much management, and when it is dry, it will be watered.
2. Choose the medium with good water permeability as far as possible.
Keep the soil moist (do not accumulate water).
4. Pay attention to ventilation
5. Don't be exposed to the hot sun.
- Prev
When will the culture method of Ji coral blossom
Ji coral looks like a cactus, but it is much slimmer than a cactus and looks very spiritual. what is the breeding method of Ji coral? When will it blossom? The culture method of Ji coral: the selection of basin soil, when Ji coral is cultivated, the basin soil should be sandy soil with good drainage and air permeability and rich in calcium.
- Next
How long is the breeding method and breeding florescence of Sugen Fu Lukao?
Sugen Fulu test flowers are very good-looking, many people like this kind of flower very much, what is the breeding method and breeding method of Sugen Fulukao? How long is the florescence of Sugen Fu Lukao? Sugen Fu Lukao's culture method: open field cultivation, should choose leeward to the sun and well drained land
Related
- Fuxing push coffee new agricultural production and marketing class: lack of small-scale processing plants
- Jujube rice field leisure farm deep ploughing Yilan for five years to create a space for organic food and play
- Nongyu Farm-A trial of organic papaya for brave women with advanced technology
- Four points for attention in the prevention and control of diseases and insect pests of edible fungi
- How to add nutrient solution to Edible Fungi
- Is there any good way to control edible fungus mites?
- Open Inoculation Technology of Edible Fungi
- Is there any clever way to use fertilizer for edible fungus in winter?
- What agents are used to kill the pathogens of edible fungi in the mushroom shed?
- Rapid drying of Edible Fungi