A Method to Save Plants from Drought, Waterlogging, Death and Insect Damage

Many people raise plants, but negligence always leads to all kinds of ways to kill plants, so you know that there are other ways to save plants when they are not dead at all. Let's go and have a look.

1. Die of drought

If the flowers and plants are not watered in time, the leaves will wilt downward from the top, and the whole plant will slowly wither and die, as shown in the picture below. The lack of water leads to wilting.

To save:

1. Clean up: cut off all the wilting branches and leaves of Rabdosia angustifolia and retain the healthy root system.

2. Re-hair: put it in a warm and bright place indoors after watering, and it will sprout again after a period of time.

Note: other flowers and plants should be watered in time in this case, pay attention to the gradual increase in the amount of water, not too much water for the first time.

Before watering, put the water next to the flowerpot for more than two hours, and wait for the water to be about the same as the soil temperature of the flowerpot.

3. Watering in time

If the soil is too dry to harden and cannot be watered, soaking basins should be chosen.

1. Soak the pot: put the flowerpot in a larger pot and add water to half the depth of the pot.

2. Take out: the water will seep into the soil through the permeable hole at the bottom of the flowerpot, and the flowerpot can be taken out after the soil on the surface of the flowerpot is soaked by water.

2. Waterlogging to death

Flowers and plants will be waterlogged not because too much water is absorbed, but because there is too much water in the soil, flowers and plants can not be absorbed, the soil is sticky, the roots are difficult to breathe, and microbes breed, resulting in rotting roots.

Save one: loosen the soil and ventilation

Gently poke away the pot soil to observe the root system, if there are no rotten roots, the situation is not serious, flowers and plants should be loosened in time, and flowers and plants should be placed in a bright and ventilated place, so that the water can be dispersed as soon as possible. But avoid strong sunlight and strong winds.

Save the second: rotting root

If the rotten root has already appeared and the situation is more serious, it is necessary to clean up the rotten root in time. Take succulent plants as an example.

1. Clean up: clean up the succulent root and remove all the rotten parts with a disinfection blade.

2. Disinfection: apply carbendazim at the cut and dry in a cool and ventilated place for one or two days.

3. Hairy root: you can put the beheaded succulent on the mouth of the bottle with water, do not touch the water at the root, or put it on perlite, red jade soil and other planting soil, waiting for it to take root.

4. Placement: put the succulent plant in a cool, ventilated and astigmatic place to avoid direct sunlight. Under normal circumstances, it can be re-rooted in about 3 weeks.

3. Burn to death

If too much fertilizer is applied and the concentration of fertilizer in the soil is too high, it will burn roots, causing the leaves of flowers and plants to be scorched yellow and gradually wither.

To save:

Take green pineapple as an example.

1. Cleaning: the green pineapple should be taken out of the flowerpot to observe whether the burnt root system has appeared, peel off and clean the soil from the root, clean the burnt root system with a sterilized blade, and remove the over-wilting leaves.

2. Change the pot: rinse the flowerpot, put it into the clean rotten leaf soil, mix with about 1/4 vermiculite or river sand, mix well and replant the green apple.

3. Take the basin: put the green pineapple in a cool and ventilated place and sprinkle water on and around the green radish leaves every day to keep moist. Under normal circumstances, you can recover in about 10 days.

4. Insect pests

Insect pests are a major nemesis of the healthy growth of flowers and plants, usually give priority to prevention, if the emergence of timely treatment, and other insects destroy the trunk of flowers and plants, it will lead to the death of the whole plant.

Save one: conservative treatment

If the diseases and insect pests are not very serious, you can choose conservative treatment, taking scale insects as an example.

1. Medication: the scale must be diluted with water at the ratio of 1 to 2000.

2. Spray: spray the potion on the leaves with insect pests.

Salvage II: thorough treatment

If the pest is already very serious and cannot be cured repeatedly, you can select the healthy part of the flowers and plants and replant the cuttings, taking longevity flowers as an example.

1. Leaf selection: select healthy longevity flower leaves, carefully cut them with sterilized blades, and leave them in a cool place to dry.

2. Matching soil: choose loose and fertile rotten leaf soil, add about 1/4 of river sand or vermiculite, pour water into the permeable hole, and insert longevity flower leaves in the soil.

3. Germination: put the flowerpot in a cool and ventilated place, keep the soil moist and wait for the longevity flowers to sprout.

Longevity flowers sprout very slowly, it takes 5-6 months, but now the flowers will bloom beautifully during the Spring Festival after re-cutting. Flower friends should wait patiently.

When you see the flowers dying, don't throw them away in a hurry. If you deal with it urgently, you might be alive.

Dying flowers, as long as the use of this trick, immediately bring the dead back to life

Die of drought

If the flowers and plants are not watered in time, the leaves will wilt downward from the top, and the whole plant will slowly wither and die, as shown in the picture below. The lack of water leads to wilting.

To save:

1. Clean up: cut off all the wilting branches and leaves of Rabdosia angustifolia and retain the healthy root system.

2. Re-hair: put it in a warm and bright place indoors after watering, and it will sprout again after a period of time.

Note: other flowers and plants should be watered in time in this case, pay attention to the gradual increase in the amount of water, not too much water for the first time.

Before watering, put the water next to the flowerpot for more than two hours, and wait for the water to be about the same as the soil temperature of the flowerpot.

If the soil is too dry to harden and cannot be watered, soaking basins should be chosen.

1. Soak the pot: put the flowerpot in a larger pot and add water to half the depth of the pot.

(author: hairy cat baby source: succulent plants.)

2. Take out: the water will seep into the soil through the permeable hole at the bottom of the flowerpot, and the flowerpot can be taken out after the soil on the surface of the flowerpot is soaked by water.

(author: bubble Man Source: Sina blog)

Waterlogging to death

Flowers and plants will be waterlogged not because too much water is absorbed, but because there is too much water in the soil, flowers and plants can not be absorbed, the soil is sticky, the roots are difficult to breathe, and microbes breed, resulting in rotting roots.

Save one: loosen the soil and ventilation

Gently poke away the pot soil to observe the root system, if there are no rotten roots, the situation is not serious, flowers and plants should be loosened in time, and flowers and plants should be placed in a bright and ventilated place, so that the water can be dispersed as soon as possible. But avoid strong sunlight and strong winds.

Save the second: rotting root

If the rotten root has already appeared and the situation is more serious, it is necessary to clean up the rotten root in time. Take succulent plants as an example.

1. Clean up: clean up the succulent root and remove all the rotten parts with a disinfection blade.

2. Disinfection: apply carbendazim at the cut and dry in a cool and ventilated place for one or two days.

3. Hairy root: you can put the beheaded succulent on the mouth of the bottle with water, do not touch the water at the root, or put it on perlite, red jade soil and other planting soil, waiting for it to take root.

4. Placement: put the succulent plant in a cool, ventilated and astigmatic place to avoid direct sunlight. Under normal circumstances, it can be re-rooted in about 3 weeks.

Burn to death

If too much fertilizer is applied and the concentration of fertilizer in the soil is too high, it will burn roots, causing the leaves of flowers and plants to be scorched yellow and gradually wither.

(author: Jiangkou Xinzhuang Group Source: flower World)

To save:

Take green pineapple as an example.

1. Cleaning: the green pineapple should be taken out of the flowerpot to observe whether the burnt root system has appeared, peel off and clean the soil from the root, clean the burnt root system with a sterilized blade, and remove the over-wilting leaves.

(author: Sage Emmanuel Source: flowers)

2. Change the pot: rinse the flowerpot, put it into the clean rotten leaf soil, mix with about 1/4 vermiculite or river sand, mix well and replant the green apple.

(author: millennium green pineapple source: green pineapple bar)

3. Take the basin: put the green pineapple in a cool and ventilated place and sprinkle water on and around the green radish leaves every day to keep moist. Under normal circumstances, you can recover in about 10 days.

Insect pest

Insect pests are a major nemesis of the healthy growth of flowers and plants, usually give priority to prevention, if the emergence of timely treatment, and other insects destroy the trunk of flowers and plants, it will lead to the death of the whole plant.

Save one: conservative treatment

If the diseases and insect pests are not very serious, you can choose conservative treatment, taking scale insects as an example.

1. Medication: the scale must be diluted with water at the ratio of 1 to 2000.

2. Spray: spray the potion on the leaves with insect pests.

Salvage II: thorough treatment

If the pest is already very serious and cannot be cured repeatedly, you can select the healthy part of the flowers and plants and replant the cuttings, taking longevity flowers as an example.

1. Leaf selection: select healthy longevity flower leaves, carefully cut them with sterilized blades, and leave them in a cool place to dry.

2. Matching soil: choose loose and fertile rotten leaf soil, add about 1/4 of river sand or vermiculite, pour water into the permeable hole, and insert longevity flower leaves in the soil.

3. Germination: put the flowerpot in a cool and ventilated place, keep the soil moist and wait for the longevity flowers to sprout.

Longevity flowers sprout very slowly, it takes 5-6 months, but now the flowers will bloom beautifully during the Spring Festival after re-cutting. Flower friends should wait patiently.

When you see the flowers dying, don't throw them away in a hurry.

Let's see if we can save it.