How to water honeysuckle? why don't they blossom?

Honeysuckle, many people are growing, but do not blossom. How to water honeysuckle? Why not blossom?

How to water honeysuckle:

The principle of watering honeysuckle is: dry and wet, keep the soil moisture at 30%.

1. Spring and summer: the temperature returns in spring, which is the peak growing season of honeysuckle. If the amount of water is sufficient, the plant is easy to grow, and the stems and leaves will mature ahead of time. In this case, there should be less watering in summer. On the contrary, if the amount of water is controlled in spring, the plant growth is normal, more watering should be done in summer, because the summer weather is hot and the evaporation is large, so the watering frequency should be increased, but not excessive watering at one time, so as not to cause stagnant water to cause root rot of the plant.

2, winter: honeysuckle cold tolerance is still strong, when watering due to appropriate reduction, depending on the soil dry and wet degree of watering, if the soil is dry, then watering, keep the soil moist.

Why doesn't honeysuckle blossom:

1, lack of sunshine: honeysuckle needs good light conditions to grow well, can not be placed in a shaded place, long-term placed in a shaded place will lead to honeysuckle will not bloom.

2. Poor ventilation: if the planting space of honeysuckle is too small, the air is not ventilated and it is difficult to grow and develop well, so it is best to build a scaffold.

3. Soil phosphorus deficiency: when honeysuckle is planted, the lack of phosphorus in the soil will lead to non-flowering, so it is necessary to increase the amount of phosphorus and potassium fertilizer and control the amount of nitrogen fertilizer.

4. Reasonable pruning: when planting honeysuckle, if the pruning work is not done well, it will not blossom. At this time, weak twigs, disease and insect branches should be removed so that nutrients can be supplied centrally.

All right, that's all for watering honeysuckle, boys and girls.

How to raise potted honeysuckle, breeding methods and precautions / proper watering of honeysuckle

Honeysuckle is a very common flower plant, honeysuckle light fragrance is very good, deeply loved by people. Especially on the country roads, honeysuckle can be seen everywhere. With the progress of pot technology, honeysuckle can also be potted at home, but many people do not know how to raise honeysuckle. Let's take a look at the breeding methods and precautions of honeysuckle.

First, how to raise potted honeysuckle, bask in the sun and water properly

Speaking of honeysuckle, I believe we are no stranger, especially some people who grew up in the countryside. Honeysuckle has become a common potted flower, so how to raise honeysuckle? The vitality of honeysuckle is very tenacious, as long as you control its watering and lighting, you can ensure that your honeysuckle is full of flowers. Let's talk about the breeding methods and precautions of honeysuckle in detail below.

II. Culture methods and matters needing attention of Flos Lonicerae

1. Cultivation

Autumn and winter is the dormant period of honeysuckle, at this time you can go to the roadside to dig honeysuckle piles. When digging, you can cut off most of the branches and retain the trunk and the necessary main branches. Cut off the main root and retain the lateral root and fibrous root as much as possible. After digging out, the root should be immediately glued with soil, brought back and planted in a medium-sized tile basin with good permeability, and carefully maintained to ensure survival.

2. Transplant potted plants

Honeysuckle transplantation is generally carried out before spring germination, courtyard cultivation is generally 2-3 plants a clump, dig deep holes, apply dry miscellaneous fertilizer and a small amount of calcium superphosphate as base fertilizer, and water thoroughly after planting; if cultivated on the balcony, you can plant 1-2 honeysuckle in a larger flowerpot and water thoroughly after planting.

3. Watering

Honeysuckle is more resistant to drought, generally Rain Water is sufficient, do not need watering, in dry weather, should be properly watered; generally sunny weather, after picking branches and leaves and flowers should be watered every 3-5 days, Meiyu season pay attention to waterlogging, summer increase watering, winter watering, and so on basin soil white again. How to raise potted honeysuckle? If you want to raise honeysuckle well, you must pay attention to watering. Let's take a look at the breeding methods and matters needing attention of honeysuckle.

4. Lighting

Potted honeysuckle is a characteristic plant that requires high light. When you cultivate it at home, you should put it in a sunny environment as much as possible. If you leave it in a bad light and damp environment, it will make honeysuckle branches thin and weak. Leaves fall off and there are many good symptoms such as less civilization. In addition, when the sprouting strip of potted honeysuckle grows to about five centimeters, paclobutrazol should be sprayed in time to avoid its crazy growth.

5. Fertilization

When changing pots for honeysuckle in spring, apply appropriate amount of cake fertilizer as base fertilizer, and then sprinkle some cake fertilizer and dry powder on the basin before each stubble of solar terms such as Grain Rain, Grain in Beard and Greater Heat, and stop fertilizing in other seasons.

6. Pruning

Pruning can be carried out in summer, autumn and winter, in general, the old branches with longer branches should be re-pruned to promote plant growth; in addition, pruning should not be excessively pruned, but should retain more trunks and allow them to spread and blossom in all directions.

7. Change the basin

Due to the limitation of the flowerpot, the potted honeysuckle has less soil capacity. after 2-3 years on the pot, the potted soil is gradually lack of nutrients, the soil is stiff, the root system growing for many years is all over the whole basin, the irrigated water is difficult to infiltrate, and the fertilizer applied is also difficult to absorb. Therefore, it is necessary to turn the basin and change the soil in time, and the time of turning the basin and changing soil should be set in the slow period of the growth of honeysuckle. After turning the basin and changing the soil, it should be watered in time, just like when it was just planted, so that the soil at the bottom of the basin should be completely wet and properly shaded, and it can be placed in the ventilated sun half a month later.

Matters needing attention in cultivating Flos Lonicerae

Honeysuckle growth temperature of 20-30 ℃, growth needs sufficient light, summer should also pay attention to shade; honeysuckle can no longer be too shady, too dry and too wet, stagnant water breeding; plum rain season to pay attention to drainage; in the second year of honeysuckle growth should pay attention to set up flower racks or move close to hedges, walls, in order to find things attached to winding climbing; when diseases and insect pests occur, we should pay attention to timely prevention and control. The above is how to raise honeysuckle, honeysuckle breeding methods and matters needing attention all the content, I hope to help you.

The method of making honeysuckle blossom, dense flower and short branch

Many friends know that honeysuckle has a certain medicinal value, and some friends want their honeysuckle branches to blossom short and dense, but how to make their honeysuckle grow in the way they want? If you want your honeysuckle to blossom, dense flowers and short branches, you must pay attention to potted plants, which are not suitable for planting on the ground, and the following methods may help you.

Honeysuckle

First, buckle the water

Honeysuckle is a vine, without interference, its branches grow fast and long. In the basin, we can break the convention by not watering it in the evening and watering it in the morning when it sprouts in spring, and watering small water instead of heavy water, so that its physiological water can not meet the needs of prosperous growth, shortening and aging new branches. When the branches are old, they are easy to blossom, while shortening narrows the distance between the internodes, and the blossoms are concentrated and flourish.

II. Fertilizer restriction

Before flower bud formation, no or less nitrogen fertilizer was applied, but relatively more phosphorus and potassium fertilizer was applied. When the flower bud is basically formed, the striping is basically over, and then appropriate amount of nitrogen fertilizer is applied to make it form a situation of multi-flower and large flower.

Third, turn the basin lazily

It only turns the basin once in 3-4 years. The purpose is not to let it sprout more new roots, the new roots are less, the absorptive capacity is poor, coupled with the basin soil aging, it is very difficult to grow, so as to achieve the purpose of controlling the tree potential, limiting branches, and blooming densely.

4. Pruning

Cut off the buds, trim the long branches, and keep the long branches short. Then put it in a sunny place (half-cloudy and half-sunny in summer) to prevent it from growing because of insufficient light.