The method and management of moving insects and raising queen bees

The tools used by the king are needles, frames, wax bowls and bowls, towels, basins, royal jelly, etc. The worm transfer needle is a tool used to transplant the small larvae into the Wang Tai bowl. It can be made of thick copper wire or goose feather tube, one end is in the shape of a thin tongue, and the other is in the shape of a spoon. The worm transfer needle with spring is easy to use. The Yuwang frame is the frame in which the king platform is placed. Can be reformed with standard frame, the width of the upper and lower frame beam and side plate is equal, about 13 mm. Three slats with a width of 10 mm are installed horizontally in the frame. The wax bowl stick is a wooden stick dipped in a wax bowl. It is 100 mm long and the end of the wax bowl is very smooth, with a diameter of 8-9 mm at 10 mm from the end. The wax bowl is the Wang Taiji that breeds the queen bee. It is made of wax bowl rods dipped in melted beeswax. Soak the wax bowl stick in cold water for a period of time, remove the water, insert it vertically into the melting wax at a depth of about 10 mm, take it out and stop for a while, dip it in this way 2-3 times, shallower each time, then put it in cold water and cool it off. The wax bowl made of the wax bowl has a thin mouth and thick bottom, which is smooth and free of air bubbles, and can also be used as a plastic king's platform. Royal jelly can be obtained temporarily from Natural King's platform, or it can be collected and stored in the refrigerator in advance. When in use, add twice the warm water to dilute the royal jelly.

(2) the method of transferring worms the king can systematically breed the required number of virgin queens with the same mature period. First of all, stick 2-3 layers of nest strips on the lath of the Yuking frame or glue a small triangular thin piece of iron with molten wax at an equal distance, stick 7-10 wax bowls, 3 altogether 20-30 wax bowls, put them into the Yukang group, let @ # 255mm clean for 2-3 hours, remove the bees with a bee broom, and place a drop of diluted royal jelly or honey inside each wax bowl. Worm transfer is carried out in a clean and bright room, with a room temperature of 25 degrees Celsius to 30 degrees Celsius and a relative humidity of 80% and 90%. If the humidity is not enough, sprinkle water on the ground. When the temperature is above 25 degrees Celsius, the insects can also be moved in the shade outside when there is no bee theft. Take a box of small larval spleen from the mother group, sweep the bees, and remove the worms. First put the lath with the wax bowl side by side on the table, use a clean round-headed thin glass stick or bamboo stick to order the thin royal jelly the size of a grain of rice in the wax bowl cleaned by the bees, and then transfer the worms. The migratory worm should drop the needle from the back (convex surface) of the young larva (one day old), the needle tip is close to the floor of the room, insert the tip between the larva and the floor of the room, pick up the larva and put it on the royal jelly in the wax bowl. Then gently pull out the worm transfer needle from below. The larvae are very tender, and the movement of moving insects should be light, steady and fast. A larva is only allowed to be picked once with a transfer needle. Cover the lath with a wet towel (so as not to lower the temperature). Move to the second one. The lath of the transferred worm is installed on the king frame and added between the larval spleen and pollen spleen in the king group. After half a day to a day, the king frame is proposed to remove the accepted larvae and re-move them into the larvae of less than one day old, which is called compound transfer. More royal jelly can be obtained by compound transplanter, and the queen bee bred by this method has better quality and higher acceptance rate than that of once transplanter.

(3) after adding the rearing king frame of the transferred worms to the management king group after the transfer, they were rewarded and fed continuously in the evening. Check whether the larvae are accepted in two days. For the accepted larvae, the royal jelly in Taichung increased, and the larvae floated on the royal jelly; the unaccepted royal platform was bitten, and there were no larvae in Wang Taichung. If you use the kingless group to cultivate the king, then transfer the king frame to the succession box with the king group, and at the same time merge the kingless group with the original group, for example, if the king group is used to breed the king, and on the sixth day the king platform has been sealed to check the sealing of the king platform, eliminate the small, skewed king platform. Count the number of available Wangtai in order to organize the number of mating groups needed.