MySheen

How to reproduce jasmine in the family

Published: 2024-12-23 Author: mysheen
Last Updated: 2024/12/23, If you need to breed jasmine flowers in the family, you can use the following methods: ① tender wood cuttings. In the first and middle of May, take the shoots that germinated in early spring, strong, about 8 cm long, pay attention to the old stem segment with 2 cm at the lower end, remove the lower leaves, leaving only 1-2 pairs of leaves at the top. The lower incision is about 0.2 cm below the node, and then the cuttings are cut in a loose matrix, pressed slightly, so that the cuttings are closely connected with the matrix, watered, and placed in a shaded and ventilated place. Move indoors on rainy days to avoid the rot of cuttings caused by rain. After that, keep the basin soil wet and spray water on the cuttings properly for about three weeks.

If you need to breed jasmine flowers in the family, you can use the following methods:

① tender wood cuttings. In the first and middle of May, take the shoots that germinated in early spring, strong, about 8 cm long, pay attention to the old stem segment with 2 cm at the lower end, remove the lower leaves, leaving only 1-2 pairs of leaves at the top. The lower incision is about 0.2 cm below the node, and then the cuttings are cut in a loose matrix, pressed slightly, so that the cuttings are closely connected with the matrix, watered, and placed in a shaded and ventilated place. Move indoors on rainy days to avoid the rot of cuttings caused by rain. After that, keep the basin soil moist, and properly spray water to the cuttings, it can root in about three weeks, that is, begin to apply a dilute concentration of liquid fertilizer, at the same time moderate light, can be transplanted and cultivated after 2 months.

② high position pressing bar. Select strong branches in spring, peel around 18 cm below the top, about 0.5 cm in width, be careful not to hurt the xylem, peel off the skin clean, then bend into the flowerpot and fix it with bamboo sticks or other things, so that the ring is buried in the soil to keep it moist, or you can wrap it with wet soil and wrap it with thin film, which can take root in about 2 months. After rooting, it is separated from the mother plant and can be cultivated as a new plant.

 
0