The Propagation method of Flower in Shrimp

Cuttage propagation

In fact, this way is planted all the year round, but spring and summer are better. In summer, cuttings need to avoid shade and moisturize. The first step is to cut the ear strips with 2-3 internodes as cuttings which are born in the same year and grow more healthily. Both old wood cutting and tender wood cutting are OK, in fact, under the same temperature conditions, the rooting speed of tender branches is much faster, and the cutting soil is more suitable to choose yellow sand, vermiculite or perlite, which needs disinfection and sterilization. The party inserts the root section 1 into the soil, and the indoor temperature had better be kept below 20 ℃. It can take root in about 10 days and blossom the following year. After the cuttings take root, they need to be transplanted into the pot in time to avoid the shade properly. After the new leaves grow, they can be moved to a sunny place.

Sowing and reproduction

First of all, of course, we need to select the seeds, and we should choose the seeds harvested in the same year, so as to ensure the germination rate of the seeds to a certain extent. The selected shrimp flower seeds should have the following characteristics: full and full, free from diseases and insect pests. Then put the seeds in relatively warm water and soak them for about 12-24 hours until the seeds absorb water and expand.

The Culture method of Shrimp Flower

First of all, shrimp clothes flowers will bloom all the four seasons, so we have to separate different seasons and different culture methods.

1. Enough light

In the spring and autumn, we need to make shrimp flowers fully exposed to light, the plant can not be in a state without sunlight for a long time, otherwise it is easy to make the plant overgrow, affecting the quantity and quality of flowering.

2. Moderate fertilization

Fertilizing in spring and autumn, we should keep enough water and fertilizer. The demand quality of shrimp flower is still very high, it is necessary to keep the basin soil moist, apply mature liquid fertilizer for once, and apply phosphate fertilizer when flowering.

3. Suitable moisture

In summer, it is a rainy season, so we should pay attention to drainage. But when there is plenty of sunshine, you still need a lot of water, so remember to spray water frequently and keep it fine, which can also lower the temperature. And if the temperature rises gradually, the light is getting stronger and stronger, remember to do a good job of shading and ventilation in time, put shrimp clothes in a cool and ventilated place, can not always shine in the sun.

The Propagation method of Flower in Shrimp

The Cuttage Propagation of Flower in Shrimp

The cuttage of shrimp flower can be carried out in four seasons, mainly in spring and summer. Summer cutting needs to be shaded and moisturized. First of all, the ear strips with 2-3 internodes were cut as cuttings. Old wood cuttings and tender wood cuttings can be used, but under the same temperature, the rooting speed of tender branches is faster, and the cutting substrate is suitable for yellow sand, vermiculite or perlite, and sterilization. Insert the basal node into the substrate and keep it below 20 ℃ at room temperature. It can take root after about 10 days and blossom the following year. After the cuttings take root, they should be transplanted into the pot in time and shaded properly. Wait until the new leaves grow out, and then move to the place where the sun is sufficient.

Sowing and Propagation of Flower in Shrimp

First of all, we need to pick seeds, and it is best to choose the seeds harvested in the same year to ensure the germination rate of the seeds. Choose full and full shrimp flower seeds free from diseases and insect pests. Soak the seeds in warm water for about 12-24 hours until the seeds swell. For smaller seeds, you can use a toothpick with wet water at one end to take the seeds, then stick them one by one on the surface of the matrix, covering the soil with a depth of about 1 centimeter, and then put the seeded flowerpot into the water, the depth of the water is 1-2-2-3 of the height of the flowerpot, and let the water soak up slowly. For larger seeds, you can put them directly into the substrate and order them at a distance of 3 × 5 cm. The depth of soil cover is about 2-3 times that of seed. After sowing, you can wet the substrate with a sprayer, and then sprinkle the soil later when the soil is slightly dry. at the same time, we should pay attention to control the intensity of watering, so as not to wash the seeds too hard.