MySheen

one。 Cutting steps of hanging Golden Bell upside down

Published: 2024-11-24 Author: mysheen
Last Updated: 2024/11/24, 1. The survival rate of cutting time hanging upside down is very strong, it is suitable for cutting all the year round, but finally in spring, because spring is the most exuberant season for upside-down golden bell growth, and the temperature is neither cold nor hot, the survival rate of cutting is also the highest. the most unsuitable for cutting in winter, it is easy to fail.

1. Cutting time

The survival ability of the inverted Golden Bell is very strong, it is suitable for cutting all the year round, but at last it is cut in spring, because spring is the most exuberant season for the growth of the inverted Golden Bell, and the temperature is neither cold nor hot, and the survival rate of cutting is also the highest. the most unsuitable for cutting in winter, it is easy to fail.

two。 Select material

For the cutting method of hanging the golden bell upside down, you need to select a good material first, pick a branch that grows well, and now leave two leaves on the branch. Such a branch is full of vitality, and it is easy to cut successfully. Then in the preparation of potassium permanganate solution, knife, and finally prepare the mixed soil of garden soil and river sand at 1:1.

3. Treatment of branches

After preparing the material, first of all, you need to deal with the branch, cut the lower end of the branch obliquely with a knife, then soak it in potassium permanganate solution for 30 seconds for 60 seconds, and finally place the branch in a cool place and dry the wound to prevent rotting roots in the process of cutting. lead to cutting failure.

4. Cuttage start

Cutting the treated branches in the prepared soil, there is no need to fertilize it, because the branches are very fragile during this period of time, fertilization will lead to its death, just need to maintain the wetness of the soil, need to be cultured in a cool place, waiting for the branches and leaves to take root and sprout can be cultured normally.

two。 Points for attention in the maintenance of new plants after cutting 1. Fertile soil

Hanging Admiralty upside down is a plant that desperately needs nutrients, so we should choose loose soil, breathable soil, good drainage and fertile soil. The amount of fertilizer application can be increased appropriately after the cuttage is successful.

two。 Watering frequency

The new plant can appropriately increase the watering frequency when cutting, but it is necessary to control the amount of watering, and when the plant is mature, it should be watered according to the habit of hanging the golden bell upside down. Spring and autumn need to spray water on its branches and leaves once a day, while in summer you need to move the inverted golden clock to the shade, then water it twice a day, control moisture in winter, and finally water it every 10 days.

3. Ambient temperature

The upside-down Admiralty is suitable for growing at 10: 28 ℃, not less than 5 ℃. It needs shade in summer and is often watered, otherwise it will wither and die.

The cutting steps of hanging Admiralty upside down are these four steps, is it very simple? flower friends can try it at home according to the method in the article, practice a lot, and pay attention to the temperature, soil, humidity and so on in daily life. only in this way can we grow a graceful inverted golden bell. I hope you can successfully cut the inverted golden bell and have more posture rich, elegant and beautiful inverted golden bell!

Hang Admiralty upside down how to cut, 6 steps to finish cutting

In fact, the upside-down Admiralty can be propagated by cutting. in addition to the summer dormancy period, the time of upside-down Admiralty cuttings can be cut in other seasons. Let's take a look at how to cuttage.

How to cut the Golden Bell upside down 1. Cutting time

In addition to the summer dormancy period, the cutting time of upside down Admiralty can be cut at any other time as long as the temperature is suitable, of course, it is better from November of each year to the middle and first ten days of April of the following year.

2. Preparation of cutting pot soil.

For the soil used for upside-down Admiralty cuttings, it is recommended to use fine river sand to clean, and to wash and disinfect with boiling water at the same time, the slotting bed can generally be used in shallow pots or wooden boxes, and it is suggested that 0.1% potassium permanganate solution can be used for disinfection in advance.

3. Branch selection

Cuttings generally choose branches that are born in the same year and have not yet lignified, with tender tips at the same time, the length of cuttings is generally 6 to 10 centimeters, and the lower leaves should be cut off at the same time. In addition, when taking cuttings, you must use sterilized scissors to make the cuttings neat and smooth. Do not pinch the cuttings directly to the plant with your hands.

4. Cutting method

It is suggested that when cutting, flower friends can first soak the cuttings of the golden bell upside down in vitamin B12 for 20 minutes, and insert a small hole in the sand with a thin bamboo stick, and then insert the cuttings into the sand hole with a depth of 3 to 4 centimeters. The distance between cuttings should be kept at about 8 cm to facilitate the pot after rooting. After the branch cuttings are finished, water them once and cover them with plastic sheeting to maintain the humidity of the bed.

5. Post-cutting management

After hanging the Admiralty bell upside down, put the cutter indoors where there is astigmatism. It is suggested that you should not receive direct sunlight at first, keep the room temperature at about 20 degrees Celsius, and then receive some light after a week.

In addition, after upside-down Admiralty cutting, you should often spray water into the bed, usually once a day in winter and once in the morning and evening in spring, so as to keep the humidity in the bed above 80%. It usually takes root about 25 days in winter and 20 days in spring.

6. seedlings are transplanted in pots.

After the cuttage takes root, the technology should be put on the basin in time, the basin soil should be disinfected without fertilizer, the basin and cultivated soil should be disinfected, and the basin bottom should be used to make the drainage layer. When transplanting, you can use a small bamboo shovel to dig up the seedlings gently, put them into a small hole dug in advance in the basin, and bury the roots with soil after straightening. Do not press the soil by hand to avoid excessive force and damage to the roots and seedlings.

After the seedlings are planted, they should be watered immediately to make the soil naturally dense, and then the pot should be placed in the shade for cultivation. If there is no wilting phenomenon in the leaves after three days, it can be exposed to light, and less liquid fertilizer will be applied a month later to enter normal management.

Detailed introduction of the methods and steps of Cuttage Propagation of Admiralty upside down

When it comes to hanging the golden bell upside down, I believe everyone will be familiar with it. Admiralty hanging upside down is a common herbal flower, which has high ornamental value and is loved by many flower friends. So, do you know the methods and steps of cutting propagation of hanging Admiralty upside down? Today, the editor will introduce the relevant knowledge to you in detail.

1. Cutting time

Except for the summer dormancy period, the golden bell can be cut as long as the temperature is suitable, but it is better from November of each year to the first ten days of April of the following year. Because this period is the peak growing season of the plant, the cuttings with strong vitality can be selected, coupled with the cooler temperature, the cuttings should not rot, and the survival rate is higher.

2. Selection of cuttings

Cuttings should choose branches that are not yet woody, preferably with tender tips, the length of cuttings is generally 6 to 10 cm, and the lower leaves should be cut off. It should be noted that when taking cuttings, you must use sterilized scissors to make the cuttings neat and smooth, and do not pinch the cuttings directly to the plant with your hands.

3. Preparation of cutting substrate and cutter.

The cutting substrate should be screened with fine river sand, but it must be washed and sterilized with boiling water. The inserting bed can be used in a shallow basin or wooden box, and it should also be disinfected by spraying 0.1% potassium permanganate solution in advance.

4. Cutting method

When cutting, soak the cuttings in vitamin B12 for 20 minutes, insert a small hole in the sand with a thin bamboo stick, and then insert the cuttings into the sand hole with a depth of 3 to 4 centimeters, and the distance between cuttings should be kept at about 8 centimeters. In order to facilitate the basin after rooting. After the cuttage is finished, water it once and cover it with plastic sheeting to maintain the humidity of the bed.

5. Plug-in management

After cutting, the cutter should be placed indoors where there is astigmatism, and should not be exposed to sunlight directly. The room temperature should be kept at about 20 degrees Celsius, and only after a week can it receive some light. After cutting, you should often spray water into the bed, spray once a day in winter and once in the morning and evening in spring to keep the humidity in the bed above 80%. It usually takes root about 25 days in winter and 20 days in spring.

6. Seedling pots

The cutting seedlings should be put on the pot in time after rooting, the basin soil should be disinfected without fertilizer, the basin and cultivated soil should be disinfected, and the basin bottom should be used to make the drainage layer. When transplanting, you can use a small bamboo shovel to dig up the seedlings gently, put them into a small hole dug in advance in the basin, and bury the roots with soil after straightening. Do not press the soil by hand to avoid excessive force and damage to the roots and seedlings. After the seedlings are planted, they should be watered immediately to make the soil naturally dense, and then the pot should be placed in the shade for cultivation. If there is no wilting phenomenon in the leaves after three days, it can be exposed to light, and less liquid fertilizer will be applied a month later to enter normal management.

This is all I know about hanging the Golden Bell upside down today. I hope it will be helpful for you to read this article. If you want to know more about the inverted Golden Bell, please continue to pay attention to the succulent flower bed. We will provide you with more related knowledge!

 
0