The culture steps of star flowers are as follows:
First, sowing seeds
The seeds of star flowers are smaller, so the seeds should be sown on the burrow plate. The hole should not be too big and too small, preferably 1.5-2 cm. Do not cover the seeds with objects during germination so as not to block the light. During this period, adequate watering is needed to promote the rapid germination of seeds.
2. Upper basin
After sowing the seeds for seven or eight weeks, the starry flowers can be transplanted into the pot. Before putting on the pot, you can fertilize properly and replenish enough nutrition to the plants. The cultivation medium requires the use of sterile peat soil with a little fertilizer and good drainage, and the pH value should be between 6.5 and 6.8.
Third, watering
In the long-term star peanuts, it is not appropriate to over-water, excessive watering will lead to plant yellowing and slow flower growth. This is due to the fact that the star flowers are not resistant to water and moisture. It is best to keep the water temperature at the same temperature as the cultivation medium.
4. Fertilization begins to be applied after the cotyledons of starry flowers are unfolded. The frequency of fertilization is watering every seven to ten days. 800-1000 times the liquid of leaf green essence can be used as fertilizer. In the growth cycle of starry flowers, 80-1000 times of flowering essence can be used as fertilizer, and the frequency of fertilization is once a week.
The above steps answer the question of how to raise star flowers. next, let's take a look at what problems we need to pay attention to in the process of star flower culture:
The Culture method of Flowers
It is suitable for cultivation in sandy soil rich in organic matter, with good drainage and good development of full-day and half-day sunshine.
Warm heat and sufficient sunshine contribute to the growth of star flowers. During the growth period, the night temperature should be kept above 17-18 ℃, and the daily temperature should be above 22-24 ℃. Temperatures below 10 ℃ will cause irregular flowering and delay or hinder the blooming of flowers.
Because the seeds are small in the seedling stage, the seedlings are often sown by cultivating hole seedlings. The commonly used sowing medium is rich in humus, good drainage and aseptic medium. The PH value is 6.56.8 and the EC value is 0.75ms/cm. Sow seeds on the acupoint plate and sow 1 seed in each hole. The size of hole planting should be 1.5-2 cm. It began to germinate about 10-14 days after sowing, and the optimum temperature was 23-26 ℃. Light was needed for seed germination and could not be covered. During germination, it should be fully watered to accelerate the dissolution of the outer layer of powdered flowers and promote germination.
Star flowers like strong light, let the seedlings receive sunlight as soon as possible after germination, so as to avoid overgrowth and promote the rapid growth of plants.
It can be transplanted into the pot 7-9 weeks after sowing, and the suitable diameter of the flowerpot is 10-15cm. Before potting, appropriate fertilization should be applied to make the plant grow strongly so as to reduce the impact on the plant. The cultivation medium uses peat soil which is aseptic, slightly fertilized and well drained. The suitable PH value is 6. 5-6. 8. Warm heat and sufficient sunshine are helpful to the growth of star flowers. During the growth period, the night temperature should be kept above 17-18 ℃, the day temperature should be above 22-24 ℃, and the temperature should be lower than 10 ℃, which will make the flowering irregular and delay or hinder the blooming of flowers.
The culture method of how to raise starry flowers
Star flowers, also known as five-star flowers, dozens of flowers gathered into a group, very gorgeous and pleasing to the eye, suitable for potted plants and layout of flower beds, flower beds and so on. How to raise the starry flowers? What is the method of breeding? Let's learn about it next.
First, how to raise starry flowers
It is suitable for cultivation in sandy soil rich in organic matter, with good drainage and good development of full-day and half-day sunshine. Warm heat and sufficient sunshine contribute to the growth of star flowers. During the growth period, the night temperature should be kept above 17-18 ℃, and the daily temperature should be above 22-24 ℃. Temperatures below 10 ℃ will cause irregular flowering and delay or hinder the blooming of flowers.
Because the seeds are small in the seedling stage, the seedlings are often sown by cultivating hole seedlings. The commonly used sowing medium is rich in humus, good drainage and aseptic medium. The PH value is 6.56.8 and the EC value is 0.75ms/cm. Sow seeds on the acupoint plate and sow 1 seed in each hole. The size of hole planting should be 1.5-2 cm. It began to germinate about 10-14 days after sowing, and the optimum temperature was 23-26 ℃. Light was needed for seed germination and could not be covered. During germination, it should be fully watered to accelerate the dissolution of the outer layer of powdered flowers and promote germination.
Second, the culture method of star flower
1. Transplant: the flowers can be transplanted into the pot 7-9 weeks after sowing. The suitable diameter of the flowerpot is 10-15 cm. 1 seedling can be planted in 10 cm pot and 1-2 seedlings can be planted in 15 cm pot. Before potting, appropriate fertilization should be applied to make the plant grow strongly so as to reduce the impact on the plant.
2. Medium: peat soil with asepsis, slightly containing fertilizer and good drainage is used. The pH value should be 6. 5-6. 8 to avoid iron poisoning and magnesium deficiency. If the pH value is lower than 6.0, due to iron poisoning, there will be a serious leaf edge burning phenomenon, which will make the plant stop growing.
3. Temperature: warm heat and sufficient sunshine contribute to the growth of star flowers. During the growth period, it is appropriate to keep the night temperature above 17-18 ℃ and the daily temperature above 22-24 ℃. Temperatures below 10 ℃ will cause irregular flowering and delay or hinder the blooming of flowers.
4. Light: the stars and flowers like the environment with sufficient sunshine. The stronger the light is, the tighter and stronger the plant will be. Therefore, in the winter of weak light and short days, attention should be paid to supplementary illumination.
5. Moisture: the star flower is more resistant to drought, but not resistant to water and moisture. During the growth period, excessive watering should be avoided, and stagnant water in the cultivation medium should be avoided so as not to induce root rot. When watering, the water temperature should not be too low (that is, the water temperature should be consistent with the medium temperature). Excessive watering will often yellowing the plant and slow the growth of flowers.
6. Fertilization: one week after planting, 800 times of chlorophyllin was applied, once every 7-10 days. When the plant enters the middle stage of growth (that is, the plant height is 8-10 cm), 800-fold solution of "flowering essence" can be applied once a week to promote flower bud differentiation and growth.
The above is how to raise star flowers and star flower breeding methods are introduced, hope to help you raise star flowers, but also want to know more about star flowers knowledge to continue to pay attention to us.
- Prev
The culture method of big snow element
1. The light big snow element does not have the high request to the light, it prefers the shade, is suitable to grow in the shady place, the leaf grows more softly. two。 The suitable growth temperature of Daxue is 15-28 ℃, and it should not be more than 30 ℃ in summer. Shading and cooling treatment should be done in time, and the air temperature in winter should be kept above 0 ℃.
- Next
Disease control of Oncidium
1. Symptoms of mosaic disease: yellowish spots appear on the leaves at the initial stage. Then the disease spot will lead to leaf necrosis, the leaf on the formation of sunken brown necrotic spots, gradually withered. Solution: clean up the diseased leaves in time, avoid the growth environment of high temperature and humidity, and appropriately increase the application of phosphorus and potassium fertilizer.
Related
- Fuxing push coffee new agricultural production and marketing class: lack of small-scale processing plants
- Jujube rice field leisure farm deep ploughing Yilan for five years to create a space for organic food and play
- Nongyu Farm-A trial of organic papaya for brave women with advanced technology
- Four points for attention in the prevention and control of diseases and insect pests of edible fungi
- How to add nutrient solution to Edible Fungi
- Is there any good way to control edible fungus mites?
- Open Inoculation Technology of Edible Fungi
- Is there any clever way to use fertilizer for edible fungus in winter?
- What agents are used to kill the pathogens of edible fungi in the mushroom shed?
- Rapid drying of Edible Fungi