How to cut the Buddha spider

Pruning

Choose the sturdy Buddha bead hanging orchid branches, and then cut off a few sections, pay attention to when cutting, preferably in the protruding part.

Bury into the ground

Put the cut orchid directly on the sand or other soft soil, then gently sprinkle a layer of soil on it, bury all its stems in the soil, and the beads can also be properly buried in it.

Watering

After planting, you must pay attention to proper watering, so that it can take root quickly.

We have learned how to cut the Buddha bead orchid, and the care after cutting is also more important, so what are the matters needing attention when raising the Buddha bead orchid? Please read on with the editor with your questions.

Buddha bead orchid how to cut, 4-step cuttage mode diagram

How to cut the Buddha bead orchid 1. Prepare the material

First of all, to prepare the Buddha bead orchid soil, generally use sand, and prepare a healthy pot of Buddha bead hanging orchid pot for cutting.

2. Branch selection

To choose a healthy Buddha bead orchid, and free from diseases and insect pests, and then cut off the branches.

Cut the Buddha bead orchid according to the length of the root knot, usually one root knot, and then cut off 2 beads in order to bury a little deeper.

3. Cutting method

Then insert the cuttings of the Buddha beads into the basin, after inserting all the branches, remember to cover them with soil, and then control the environmental humidity between 50% and 60%, which usually takes about 10 days to half a month to take root.

4. Late maintenance

Flower friends need to take good care of them after cutting. remember to strictly control the amount of watering and keep the pot soil in a state between dry and wet, which is more conducive to the growth of orchid plants.

Introduction to the method of cutting pot cultivation of Magnolia lanceolata

The reproduction of Buddha bead orchid mainly depends on cutting. some flower friends' cutting has failed several times. I don't know how Buddha beads are cutting. below, the experienced flower friends' Buddha bead cutting experience has survived almost 100%. Typing 10,000 words is not as good as two pictures. I will explain the key points.

1. Cut the Buddha beads to be cut according to the length of the root knot, usually one root knot, and then cut off 2 beads in order to bury them deeper.

2. Then insert it into the basin. The following picture shows the two pots that have been cut. There are flower friends asked what kind of soil, I use gentleman orchid soil, vermiculite, perlite 1/3 each, there is no water. If the water retention is too good, it will rot easily.

Flower friends need to pay attention to: there is a root knot to take root, it is difficult to take root without a root knot, so we should cherish the root knot, even if there is only one bead above, it can still grow new beads and must be buried deeply, otherwise the beads will be pulled out if they grow in the future.

Ps: my daily maintenance method, the summer temperature is high, humid, so do not see the bright light, see the sun for an hour in the morning, less watering, ventilation, wet and dry, especially in the summer. The air is dry in winter, the sun is not strong, but bask in the sun more than in summer, and the soil surface is watered when it is dry. When I water it, I will increase it. I am in the north.

The above is the introduction of the cutting methods provided by the succulent garden. I hope you can get something after reading this article!