An old towel green apple grows big white root in 5 days and swishes all over the basin.

What should I do if the cuttings are always dead? It must be that you didn't use the right method. Huahua will teach you a few secret cutting tips today, as long as you use some old towels, sponges and other careful machines to ensure that you become green fingers.

Green pineapple cuttage with an old towel, 5 days out of white root!

1. Cut off the healthy and sturdy vines of green pineapple, be sure to take root with gas, it is easier to survive.

two。 Cut the green rattan strips into small segments with clean scissors, keeping 1 aerial root and 1-3 leaves in each section. Note that the cut is cut obliquely.

3. Cut green radish branches, put in carbendazim or potassium permanganate or aspirin solution, soak for 20 minutes disinfection, and then take out to dry for half an hour.

4. Take an old towel, soak it in water, then wring it out slightly to make sure the towel is moist but not dripping.

5. Wrap all the green branches with a wet towel.

6. Mix the rooting agent and water according to the ratio of 1: 1: 1000, put it in a spray can and spray it on the towel. if there is no rooting agent, you can use willow water, aspirin water and rice vinegar instead. After spraying, put the towel in a plastic bag to moisturize and keep warm.

7. After that, when you see the towel dry, spray root water on it. In about 5 days, the green apple will grow long and white roots!

8. After taking root, take out the green vines, plant them in loose and breathable soil, put them in a place with astigmatism and ventilation, and slowly slow down the seedlings.

Applicable flowers:

Towel cutting method is suitable for climbing vine flowers such as green pineapple, ivy, peony orchid, fragrant vine, clematis and so on.

Rose cuttage block sponge, no black pole, survival rate 100%

1. Cut off the healthy branches of the rose, about 5-10 cm, leaving 2-5 leaves, cut flat at the top and oblique at the bottom. After cutting, soak in carbendazim solution for 20 minutes.

two。 The dishwashing sponge at home can be used to cut the rose, wash it, and cut it into several small squares for spare.

3. Take the sponge and cut a gap in the middle with scissors. Don't cut too hard to ensure that the sponge can be broken by hand and closed after release.

4. Insert the rose branches to be cut into the gap of the sponge and spray the sponge wet.

5. Put the sponge with rose branches into a plastic bottle or beverage bottle and pour a small amount of mineral water or pure water at the bottom. The water level is about 2-3 cm, less than half of the sponge.

6. Put the plastic bottle on the south balcony and east-west balcony with good light, and receive the light, so that the leaves can carry out more photosynthesis and provide nutrients for long roots.

7. About a week or so, rose branches began to take root. Pour water into the bottle when there is no water at the bottom.

8. Half a month later, the root system of the white flower was covered with the whole sponge.

9. After the root system is full, we can transplant it into the pot. the sponge does not need to be cut off, it is directly connected to the branches and planted in the soil together, without affecting the growth of the root system.

Applicable flowers:

Sponge cutting method is suitable for cutting woody moisture-resistant flowers such as rose, triangular plum, gardenia, jasmine, sweet-scented osmanthus, camellia, etc., but not suitable for non-moisture-resistant flowers such as longevity and succulent plants.

Jasmine cuttings, with a foam board, swishing roots!

1. Cut off the flowering branches of jasmine, as shown below, 2 segments, cut flat at the upper end, oblique cut at the lower end, and retain a pair of leaves at the top!

two。 Find a foam board, drill a few holes in the middle, insert the jasmine branch into the hole, and then put it in a basin filled with water to make sure the bottom of the branch is exposed to water.

3. As soon as 10 days, the branches of jasmine can take root!

(photo author: monkey King)

4. When the root system is much longer and the length is more than 5 cm, you can prepare for the pot. Find a smaller flowerpot or disposable cup.

5. Find a container that is a little bigger than the flowerpot above. There can be no water holes at the bottom.

6. Pour some water into the outermost container so that the water will soak into the flowerpot through the hole in the flowerpot to make sure that the water level is lower than the jasmine root system.

7. Holding a long-rooted branch of jasmine in one hand and filling a flowerpot with soil.

7. After the soil is filled, put the whole device in a place with astigmatism and ventilation. If there is no water in the basin, add water to it. In this way, the moist soil will make the aquatic jasmine root system have a gradual adaptation process, and the survival rate will be high!

Applicable flowers:

Foam cutting method is suitable for cutting most flowers such as gardenia, jasmine, rhododendron, camellia, rose, rich tree, duck foot wood, petunia, periwinkle and so on.

Camellia cuttings, dipped in some mud, swishing white roots!

1. Cut off the semi-lignified branches of the camellias with 3-4 bud points, cut the lower end of the branches obliquely, cut off the lower leaves, leaving only 2-3 leaves at the top and leave them in a cool and ventilated place to dry.

two。 After the branches are dried for 10-20 minutes, pick up the branches and dip the bottom with a little mud, which is the usual yellow mud or red mud, mixed with carbendazim and water, and dipped in the branches can greatly improve the rooting rate.

3. You can also directly use mud to wrap the bottom of the camellia branches with a mass of mud.

4. Insert the mud-wrapped branches into the river sand or vermiculite, about 3-4 cm into the soil, pour water thoroughly, then cover the whole cutting device with a plastic bag, pierce a hole or two to breathe, and place it in a place with good light.

5. Every half month, open the plastic bag and water it if the soil is dry. In about 2-3 months, the branches take root.

6. After the root is much longer, it can be transplanted into the pot!

(photo author: Camellia is highly poisonous)

Applicable flowers:

Mud cutting method is suitable for woody flowers such as camellia, sweet-scented osmanthus, rhododendron, gardenia, jasmine and so on.

Triangular plum strips, set a plastic bottle, fast molding, high survival rate!

1. First of all, we choose a strong triangular plum branch, use a wallpaper knife to peel the place in a ring, carve out a wound about 1-2 cm wide, and then peel off the surface bark so as not to hurt the xylem.

two。 If the branch of triangular plum is longer, we can do 2-3 ring peeling on this branch, and we can press 3 triangular plum at the same time!

3. Find a plastic bottle, cut it like this, and circle it around the bark.

4. Then use tape, the plastic bottle cut location and the lower end glued together, loaded with soil, you can use garden soil, you can also use nutritious soil, but must be exposed to disinfection in advance.

5. Wrap the upper end of the plastic bottle with a plastic bag or film.

6. If you see the soil in the plastic bottle dry, you can make a small hole in the plastic bag and water it.

7. About a month or so, we can see through the plastic bottle, inside the growth of strong roots!

8. After taking root, we can cut off the branches, open the plastic bottle, and plant the long-rooted triangular plum into the basin!

Applicable flowers:

Plastic bottle high-altitude striping method is suitable for triangular plum, rose, sweet-scented osmanthus, camellia, rhododendron and other woody flowers, as well as figs, pomegranates and other fruit trees.

Rubber tree cuttings, use a piece of toilet paper, take root!

1. Cut off healthy branches of rubber trees, leaving only 2-4 leaves at the top, and cut off the rest to reduce consumption. Oversized leaves can also be cut in half.

two。 Soak the treated rubber tree branches in carbendazim solution, take them out 2 hours later, and leave them in a ventilated place to dry.

3. With ordinary toilet paper, wrap the bottom of the rubber tree branches, not too tight, the thickness of the package is about 1 cm.

4. Spray water on toilet paper and wet it.

5. Throw the branches into the plastic bag and stick a few holes in the plastic bag to breathe.

6. Put the plastic bag in an astigmatic and ventilated place and spray water into the toilet paper when you see that the toilet paper is about to dry. About 2-3 weeks, rubber tree branches will grow strong roots!

Applicable flowers:

Toilet paper cutting method is suitable for most flowers such as rubber tree, happiness tree, rubber tree, money tree, periwinkle, petunia, gardenia and so on.

Today's cutting Secret

Huahua will introduce you here first.

If you think it's practical,

Collect and share quickly.

Live up to Huahua's painstaking efforts!