Planting techniques of sand jujube

Elaeagnus angustifolia is a famous fruit tree in northwest China. It has a wide range of uses. It can not only be eaten but also used to feed livestock. It is widely loved in northwest China. Due to the perennial exposure of fruit trees in its location, the fruit has a high sugar content and is delicious to eat. And many fruits, Elaeagnus angustifolia also has a certain effect of digestion, but should not eat more. You see here must want to know how to grow it.

1. Cultivation and seedling raising

Elaeagnus angustifolia seed sowing methods there are several, if it is the beginning of winter is generally clean the seeds, and then buried in the sand inside, in the sand above the water, such as natural germination after winter, water to wet the surface of the sand about 20 cm. If it is spring or autumn sowing seeds can be soaked in warm water for 1-2 days, and then mixed with a certain amount of livestock manure poured water to promote its germination. The land for seedling raising is leveled into ridges, which is helpful for seedling management, and a distance of one person's width can be reserved between each ridge.

2. Transplanting seedlings and inserting rods

When the seedlings grow to more than 60 cm, they can start transplanting. If there is no seedling, they can also choose to cultivate Elaeagnus angustifolia seedlings by inserting rods. The time of transplanting seedlings should be selected in relatively cool weather, so that the seedlings are not easy to die. The way of inserting rods can be selected to cut off the branches of older and vigorous trees, the length of which should be controlled at about 20 cm, and the branches to be cut off should be controlled at 4-5 branches. Seedlings and cuttings need to apply certain organic fertilizer after planting, and then irrigate a little water.

3. Planting management

Elaeagnus angustifolia trees do not have high requirements for water, so they do not need to be watered when planting. Instead, they should pay attention to drainage when there is more precipitation. Usually pay attention to its root sand cleaning, Elaeagnus angustifolia root sand push too high will affect its growth. Conditional protective measures can be properly set at the root. Pay more attention to the cutting of the stem to avoid decay caused by too high temperature or death caused by too low temperature. The initial cuttings need 2-3 times of watering per day, soaking the surface layer by about 2 cm.

4. Precautions

Elaeagnus angustifolia trees have a relatively high temperature requirement, and temperatures below 10 ° C will cause damage to them. Therefore, there must be measures to prevent low temperatures. Although Elaeagnus angustifolia trees like sunshine, the light time in northwest China is very long, so it is necessary to take protective measures against shading at the early stage of planting to avoid the death of seedlings caused by sunlight. The middle and late Elaeagnus angustifolia trees will begin to blossom and bear fruit at a higher temperature, and appropriate topdressing should be applied at this time.

Elaeagnus angustifolia itself was a plant with strong adaptability and vitality. Therefore, after the best protection in the early stage, the probability of death in the later stage was relatively low. When everyone planted it, it was also the early stage. I hope you can refer to the above information. Many key points still need to be fully reflected when planting. You can pay more attention to the information on our website.