Planting method of Snake skin Fruit

Snake skin fruit was mainly produced in Indonesia, because the climate there and other conditions were the most suitable for snake skin fruit growth. However, snake skin fruit in Qi market was imported, so the price was very expensive, and it was not necessarily available. Its skin was very similar to snake skin, but it was white after peeling. It was a bit similar to garlic. It had the effect of developing human brain memory, but there would be side effects if it was not eaten too much. Today, Xiaobian brought you the planting method of snakeskin fruit. I hope you can like it.

1, planting conditions

The requirements for planting conditions of snake skin fruit are relatively strict. Snake skin fruit is a plant that likes light, heat and humidity. Therefore, the planting conditions must have high temperature and high humidity. Usually, the average temperature of the whole year should reach 22 degrees Celsius or above. The minimum temperature should not be lower than 18 degrees Celsius, otherwise it cannot grow normally. Secondly, there should be at least eight to ten hours of light every day. The humidity in the air should be maintained at about 80%. Then after selecting the planting land, it is necessary to carry out soil preparation. Soil preparation is generally carried out through full cultivation, and the planting holes are dug according to the length, width and height of 50 cm respectively. Finally, sowing can be carried out.

2. Scientific planting

There are two ways to plant snakeskin fruit, namely seed sowing and sprout planting. Seed planting requires only placing seeds in dug planting holes, then covering seeds with soil, and finally watering. The sprout planting is to select the thick sprout of snakeskin fruit, put it in a container for cultivation, take it out after 60 days, separate the roots with different roots, and then plant it.

3. Field management

The field management of snakeskin fruit is mainly water management, heat management, nutrient management and pollinating tree matching management. Before planting, we have selected the area close to water source, and selected the area with high rainfall and sufficient heat for planting. At the same time, we need to install hygrometer and thermometer in the forest. In this way, humidity and temperature can be managed at the same time. Once humidity and temperature are found not up to standard, they must be adjusted in time. The second is to need at least three times a year of fertilizer, so that the nutrients in the soil can make the snake skin fruit grow normally, and when planting, we should pay attention to the proportion of male and female trees, so that the result will be high. After renting, it is necessary to control the growth of branches and leaves of snake skin fruit seedlings and not to grow too densely.

4. Artificial pollination

The probability of successful natural pollination of snakeskin fruit is not very high, so the annual yield is very low, so when the snakeskin fruit blooms, we had better use artificial pollination to pollinate, so as to improve the yield of snakeskin fruit. First, we need to collect the pollen of male flowers, then use a special pollination brush to smear the pollen on female flowers, and finally use a layer of plastic film for protection, so that the success rate of pollination will be higher.

5, pest control

According to the relevant growers, the resistance of snakeskin fruit trees is extremely strong, so there are basically no diseases and insect pests throughout the year. Only occasional beetle pests appear, mainly harming the roots of snakeskin fruit seedlings. In serious cases, they lead to plant death. Therefore, timely prevention and control can be carried out. You can use chemicals for beetle irrigation. At the same time, ordinary growers have a local method, which is to irrigate with rabbit urine. This kind of control effect is also very good.