1 pot of meaty cuttings becomes 10 pots of meat toot

In summer, flower friends take good care of them every day for fear of any mistakes in succulent plants. Unexpectedly, they still fail to help them escape the ravages of summer. Some succulent plants leave because they can't stand the heat, leaving behind a pile of withered leaves. This can make flower friends extremely sad.

Now it is not easy to wait for autumn, flower friends are cheered up, try to use succulent cutting method to remedy, Xiaobian today to flower friends to share a "plastic bottle" for water and then on the pot method, in accordance with the steps of this method to cuttage, raised succulent can be changed into 10 pots, each fleshy toot.

Step 1: the method of selecting leaves by inserting succulent leaves

The choice of succulent leaves is fastidious, not thin leaves, but thick leaves. Because thick leaves contain more water, nutrients are also absorbed more, we do not need to add any nutrients to it in the process of cutting, and thin leaves do not store much water, if the weather is hot, it is easy to dry up.

Step 2: the method of cutting leaves by inserting succulent leaves

For some closely related succulent plants, if you break it off directly, it is very likely that it will be broken in the middle of the break and waste the leaves. It is best to cut off with a blade, because the blade is small and can be shuttled back and forth between the succulent leaves without hurting other leaves.

The blade cannot be used directly and must be disinfected first. Drop 3-4 drops of medical alcohol onto the blade, wipe it with a clean towel, and then put it in a ventilated place to dry. When it is dried, you can slice it. The blade is chosen at the bottom, because in the process of cutting, you need to bend the leaf slightly with one hand and cut with a blade with the other.

Step 3: the "water insertion" method of succulent leaves

First of all, you have to find a large mineral water bottle that is clean and free of water stains, and then use scissors to poke a few small holes around the bottle. The scissors should also be soaked and sterilized with alcohol, and you can use them directly instead of drying them.

Then insert the prepared succulent leaves into the holes of the plastic bottles, insert them into 1/2 of the leaves, and finally pour water into the plastic bottles, with the general water level touching 1/3 of the leaves. Generally, in about half a month, the leaves will produce new roots and leaves, which can be transplanted into the potted soil.

Step 4: the method of selecting soil by inserting succulent leaves

You can buy nutritious soil, or you can configure it by yourself. if you prepare it, you only need to prepare perlite, river sand and coconut bran soil, soak a shovel with alcohol, dry it and mix it, stir it evenly and accumulate in a sunny place for 3 days. It's OK, it's best to spray with carbendazim diluted with water 800 times before use, so as not to have bacteria.

Step 5: the "fertilizer" method of planting succulent leaves

This step, very important, must not be ignored, succulent just on the pot, not yet so fast, can not be fertilized. After a week, flower friends can use a special nutrient solution for succulent plants to spray 800 times diluted with water every 10 times, which can promote succulent plants to take root and sprout continuously.

The above is the method of succulent cutting, with good use, a pot into ten pots, each fleshy toot is not a dream.