The key to the domestic rose is this cut, which makes the flower bloom twice as much as the single branch becomes the sea of flowers.

People grow roses for the flowers they bloom in, and we're trying to do it in a variety of ways. If you are a beginner in this area, then you may be able to make the rose bloom better by watering, fertilizing, ventilation, etc., but if you ask the old gardener, they will answer that these are just accessories, want the rose to bloom well, or have to use its own growth rules, it is better to say that we are going to introduce today's "top advantage."

Small "top" university questions!

What is a top advantage? In fact, to put it bluntly, it is the phenomenon that the top of the plant grows preferentially and the lateral buds are suppressed. It is reflected in many plants, and the more obvious the top advantage it gives, the more concentrated the nutrition is in the upper part of the plant. Therefore, the nutrition of the community located in the middle and lower parts is much less. Such flowers stand out as a standout, but it is obvious that roses are not suitable for plants that pursue flowers.

However, if we operate reverse thinking and transfer the nutrients at the top to the branches in the middle and lower positions, won't we be able to make the rose burst? And in fact, it is true that our top advantage is used in this way!

Move the scissors, the rose is indispensable!

After understanding the specific working principle, the next operation is very simple, just need to move scissors can be easily done.

First of all, prepare a pair of scissors fully disinfected with alcohol or potassium permanganate, cut off the top buds of the branches that originally had the top advantage. When cutting, you can be ruthless, because if it is not in place, you cannot break the top advantage at all. You can measure the gap between high and low branches with a ruler in advance, so that it is easier to cut down.

Pay attention to leaving a few leaves when cutting, otherwise the branches will not be able to carry out normal photosynthesis, which is very unfavorable for the growth of roses. Basically, the height of the branches can be kept consistent at a glance, then the position of the branches to be cut is properly disinfected, and finally placed under ventilated conditions and watered thoroughly.

About a week or so, we will be able to see the new shoots, and so on after the wound completely healed and then put the whole pot of roses on the balcony planting, and do a good job of fertilization, the next to meet us is a flower sea.

Of course, in addition to the above method, we can also use the "traction" method, the original upright rose branches with a heavy weight down to make it parallel branches, so that the original top advantage is broken, in the re-built potted plant, because all the buds are in roughly the same horizontal position, so the growth hormone will be reconfigured, so that more buds than the natural state can be produced, and a large number of flowering branches germinate.