Stunned, it turns out that it is only when the flowers are getting shorter and shorter that the master regrets to know.

Many flower friends have seen some very old bonsai plants, which are not as tall and tall as ordinary flowers, but rather short, but there are not a few flowers at all. It turns out that many flowers are not the taller the better (except for some lianas), but also should be properly dwarfed, not only the plant is not easy to lodge, the plant shape is beautiful, maintain a beautiful ornamental posture! Let's have a look!

"

Pot dwarfing "

Flower dwarfing sounds like a great knowledge, but it is actually easy to operate, and many of our usual ways to maintain flowers also include dwarfing plants. Today, let's take a systematic look at the ways to dwarf flowers.

-cutting grafting dwarfing-

We usually cultivate plants with cuttings, striping, split, grafting methods can play a role in dwarfing. These methods can shorten the flowering stage and lower the height of the plant, so that the plant shape is more compact.

Dahlias and sunflowers can even be cut with small buds. After dwarfing, the plant shape is more compact and more beautiful.

Grafting can not only be grafted from the root of the plant, but also play a role in dwarfing.

-pruning, plastic surgery, dwarfing-

Plants can be dwarfed by pruning and shaping. If the plant is overgrown or the trunk is too high, the trunk can be cut short. Can promote the germination of lateral branches, and then the whole plant is a very plump but not scattered state.

Plants can be dwarfed by picking hearts. Coring is to remove the top buds, which is conducive to nutrient accumulation, lateral branch growth, plant dwarfing, Dali chrysanthemum can produce more flowers after dwarfing in this way, and the flowering period will be prolonged.

-controlling the dwarfing of water and fertilizer-

It is important to fertilize just the right amount. Too little fertilizer can not fully promote plant growth, lack of nutrients become thin. On the other hand, too much fertilizer is easy to grow, which leads to insect pests and is also vulnerable to freezing damage in winter.

Therefore, we should pay attention to fertilization, the plant can apply too much nitrogen fertilizer, nitrogen fertilizer will promote the growth of branches and leaves, easy to make the plant grow too much. Therefore, it is necessary to control the proportion of nitrogen, phosphorus and potassium, especially in autumn, and appropriately reduce the proportion of nitrogen fertilizer.

-increase sunshine dwarfing-

Sunlight is one of the most basic conditions for plant growth, and plant growth, development, flowering and fruiting can only be completed under light. Different plants have different requirements for light, for many flowers, if the light is sufficient, the plant is not easy to grow, and the plant type is more compact and beautiful. But do not suddenly increase a lot of light, plants may wither because they do not adapt.

-dwarfing with regulators-

Some regulators can also be used to regulate the growth of plants.

It can inhibit the vegetative growth of plants, promote the dwarfing of plants, and improve the appearance of plants.

Paclobutrazol can shorten the internodes of plants, reduce the leaf area, deepen the color of leaves, and improve some bad performance of plants. Calla lilies often use this method.

Thalidomide, which can reduce plant height by about 26%, and make stem nodes shorter, more branches, the whole plant will be more compact.

To sum up, flowers can be dwarfed by pruning, controlling water and fertilizer, increasing light, grafting cuttings, and using growth regulators. However, dwarfing plants are not as short as possible, but allow them to put on the most beautiful posture on the basis of the most suitable height. The more beautiful the flowers are, the happier they are, aren't they?

It turns out that the masters do not raise the flowers higher and higher.

It's getting shorter and shorter.

Did you learn it?

Welcome to show it to the flower friends in need!