How to cultivate Anthurium andraeanum in Aquatic Culture
1. Transplant
First dig it out of the soil, then cut off the rotten roots and leaves, rinse with water, then disinfect it with disinfectant, and then wash it again with water. If you keep it in a glass container, put a black plastic bag on the outside of the glass in case the light is too strong, then put a transparent plastic bag on it, then put it in a place of astigmatism and keep the temperature above 10 degrees.
2. Configure nutrient solution
Take a look at its nutrient solution first. it usually takes 7 to 10 days to change. Then remove the mucus and algae from the roots in time. In summer, you can change the water a little bit, every 2 to 3 days is the best, and each change of water can not add too much water to prevent the root from rotting.
3. Adapt to the environment
It likes warm and humid places and is afraid of bright light, so pay attention to the position when raising it, and it is best to put it in a place with good ventilation and no strong light. Then in summer, the temperature should not be higher than 28 degrees, and the humidity of the air should be kept at 80%. If it is too dry, spray water on its leaves appropriately. In winter, the temperature should not be too low, or frost damage will occur.
4. Reasonable increase of oxygen
When cultivating it in water, the content of oxygen is very important. If there is not enough oxygen, it will rot its roots, so when raising it, you should use the method of vibration and gently shake the container in hand to increase the amount of oxygen.
5. Root repair
In hydroponics, the roots of its original soil should be removed so that it can grow new roots again.
6. Change the water in time
Its root absorbency is very strong, need to change the water regularly, and remove the mucus and algae from the root, so as to increase the oxygen content, it is usually best to change the water every 2 to 3 days, and once a week in winter.
- Prev
How to keep Anthurium andraeanum more exuberant
If you want to make the red palm more exuberant, you should provide it with appropriate light, but do not get high-temperature direct sunlight, keep the basin soil moist, and do not have stagnant water; fertilize once every half a month, in the morning or evening; and make the soil slightly acidic to facilitate its growth. In addition, remember not to clean the air root.
- Next
How to split Anthurium andraeanum
When Anthurium andraeanum is ramet, it is necessary to determine the ramet time, that is, the ramet time and age, prepare before the ramet, prepare the loose and breathable soil, select the mother plant, separate the mother plant from the daughter plant, disinfect the daughter plant, plant the sterilized sub-plant in the pot, do not have too many daughter plants in the basin, and do a good job of maintenance.
Related
- What if the leaves of potted flowers turn yellow?
- Florescence Control of several Flowers
- Anti-freezing technology and post-freezing nursing technology of flowers
- What is the classification of flowers? What are the common methods of flower classification?
- Prevention and control of alkali and acid damage of flowers in courtyard
- Technology of Anti-freezing and restoring growth of Flower seedlings in greenhouse and greenhouse
- How does flower fertilization not hurt the root? Fertilization technology of flowers
- Key points of disinfection in flower greenhouse
- Several pesticides that are banned or used cautiously in flowers
- How to fertilize the flowers that watch the leaves?