MySheen

The longevity flower is so trimmed that the bud can't even be seen with leaves.

Published: 2024-11-24 Author: mysheen
Last Updated: 2024/11/24, Longevity flowers, colorful, long florescence, easy to feed, many people like to raise a pot. In the process of breeding, we need to master the methods of patient management, watering and fertilization, and pruning is also very important. here is an introduction to longevity flowers.

Longevity flowers, colorful, long florescence, easy to feed, many people like to raise a pot. In the process of breeding, we need to master the methods of patient management, watering, fertilization and so on, and pruning is also very important. the following is to introduce the pruning methods of longevity flowers. Proper pruning can make longevity flowers blossom continuously.

How to trim longevity flowers?

(1)。 Longevity flowers are usually pruned in spring and autumn; pruning branches before flowering, about before September, can provide sufficient nutrients for longevity flowers to bloom and avoid nutrient consumption. After flowering, the residual flowers need to be pruned in time to avoid the consumption of nutrients, which is ready for the next flowering.

(2)。 Branches that are too dense and too long need to be pruned, and branches that generally exceed 12cm need to be truncated in time. At the same time, old and weak branches, as well as yellow leaves and withered leaves also need to be cut off, starting from the connection between the branch and the main pole, so that the branches and leaves can be evenly distributed, ventilated and ventilated. Staying will only affect the ornamental value, but also consume the nutrients of the plant, which is not conducive to flowering and plant growth.

(5)。 After the cuttings survive, wait until the plant grows to 5CM or so, cut off a pair of new buds at the top, and prune them according to the growth situation, which can restrain the apical dominance of longevity flowers and avoid exuberant tip growth.

(3)。 Longevity needs pruning after flowering, generally in the second week after flowering, the old branches and residual branches are pruned directly, and then the bud that can not bloom is cut off, otherwise the growth of the plant is affected. The flower branches should also be pruned from the first pair of leaves and the second pair of leaves. Spray water on the wound after cutting, which is conducive to recovery and continued growth.

(4)。 The height of the pruned plant needs to be paid attention to, leaving at least 5cm. The first pruning leaves at least the height of the 5CM, and the later normal pruning is generally maintained at the height of the 12cm, pruning the part of the plant higher than the 5CM before the bud appears. This is conducive to plant photosynthesis and can produce sufficient nutrition.

 
0