The planting method of Ranunculus Ranunculus
1. Choice of time
Generally speaking, October to November is better. However, the basic requirement is that the temperature is not too high. This is because the root tuber must be treated with water absorption before it can be planted. If the temperature is too high, the root root is easy to rot, so the low temperature is safer. It can be adjusted according to the specific conditions of different regions.
2. Selection of containers
The hole at the bottom is larger, which is good for drainage. The wall of the flowerpot is thinner so that it is more breathable. Generally speaking, flowerpots with a caliber of about 18 centimeters can be planted with three or five fibrous roots.
3. Preparation of matrix
You can first use a layer of rough to put at the bottom of the flowerpot, so it is easy to drain. The main matrix can be prepared with rotten leaf soil, garden soil and sand, and an appropriate amount of bone meal is added to increase nutrients.
4. Treatment of root tuber
Bury the root in the sand, wet the sand, wrap it in a plastic bag and put it in the refrigerator. In about a week or so, the water absorption process of the root tuber is completed. However, if the planting time is relatively late and the temperature is lower, there is no need to put it in the refrigerator.
5. Sowing and treatment after sowing
Put the matrix in the container, and then bury the tuber root down into it. Then fill in the soil, just cover the top of the bulb. The soil covered should not be too thick. After that, pour water thoroughly and put it in a semi-overcast, ventilated place. Wait for this stage of germination, do not water.
- Prev
How to trim the old leaves of Tiger Pilan
Generally speaking, the old leaves of Tiger Pilan can not be trimmed. However, they sometimes affect the overall viewing effect. From this point of view, can be properly trimmed, cut off the dry tip, yellowing of the old leaves can be. Medicine is needed after pruning to avoid wound infection. However, compared to pruning, it is more important to divide the basin, once every two years.
- Next
How to water buttercup
Buttercups are more resistant to drought, but afraid of waterlogging. When you first plant, you should use the soaking basin method to pour water once. In the growth stage, it is necessary to control the water at the initial stage, ensure an adequate water supply in the peak period, and water it once a day. However, in summer, it is necessary to properly control and reduce watering, otherwise it is easy to rot the roots, just spray some water. Watering can be reduced or not watered in winter.
Related
- What if the leaves of potted flowers turn yellow?
- Florescence Control of several Flowers
- Anti-freezing technology and post-freezing nursing technology of flowers
- What is the classification of flowers? What are the common methods of flower classification?
- Prevention and control of alkali and acid damage of flowers in courtyard
- Technology of Anti-freezing and restoring growth of Flower seedlings in greenhouse and greenhouse
- How does flower fertilization not hurt the root? Fertilization technology of flowers
- Key points of disinfection in flower greenhouse
- Several pesticides that are banned or used cautiously in flowers
- How to fertilize the flowers that watch the leaves?