How to trim the old leaves of Tiger Pilan
1. Whether the old leaves need to be trimmed
Generally speaking, old leaves can be trimmed or not trimmed. However, sometimes the old leaves can affect the ornamental effect. So, it's best to trim it. Moreover, the growth of plants is very exuberant. Therefore, proper pruning is also good for the plant.
2. How to trim old leaves
Pruning old leaves is relatively simple, and the number of pruning is not many, and there is no fixed pruning time. When the tip of the old leaf is dry, it affects the ornamental and needs pruning. Moreover, it only needs to be trimmed properly, and the degree does not need to be too intense.
3. Points for attention
If it is trimmed in summer, the wound is easy to rot. Therefore, after pruning, you can put some disinfectant on the wound to help the wound recover.
4. On the division of basins
Compared to pruning, dividing the basin is more important. Basin division needs to be carried out on a regular basis, usually once every two years. Every spring, the flowerpot is upside down and the plant is taken out. Then, separate the mother from the child. Put the two into the basin separately. The soil used in the pot should not be too deep. In addition, it is best to mix some furnace ash into the soil. After planting, it is best to use a rope to fix the plant and release it a month later. Also remember to fertilize properly, and the plant will grow very well.
- Prev
How to make Tiger Pilan sprout
To promote tiger Pilan to sprout, to use suitable soil, mainly use humus soil, and add some bamboo charcoal, and put a layer of stone on top of the soil. In addition, pay attention to the light, it is best to put it in the place where the scattered light shines. Fertilization is also indispensable, once or twice a month. Also provide the right amount of water, and scrub the leaves with clean water, etc.
- Next
The planting method of Ranunculus Ranunculus
It is better to plant buttercups and balls from October to November. The container can use flowerpots with thinner walls and larger holes in the bottom. The matrix can be prepared by yourself. First of all, the budding treatment was carried out. After that, put the sand in the container and bury the bulb. Water thoroughly once, and then in a semi-overcast place. Be careful not to water the sprouting period.
Related
- What if the leaves of potted flowers turn yellow?
- Florescence Control of several Flowers
- Anti-freezing technology and post-freezing nursing technology of flowers
- What is the classification of flowers? What are the common methods of flower classification?
- Prevention and control of alkali and acid damage of flowers in courtyard
- Technology of Anti-freezing and restoring growth of Flower seedlings in greenhouse and greenhouse
- How does flower fertilization not hurt the root? Fertilization technology of flowers
- Key points of disinfection in flower greenhouse
- Several pesticides that are banned or used cautiously in flowers
- How to fertilize the flowers that watch the leaves?