How to raise lilies after flowering
1. Shaping and pruning
Proper pruning can be carried out after the plant is in bloom, but it should be noted that the pruning time should not be at noon, the best in the morning or evening, so that its normal growth will not be affected. When pruning, cut off the residual flowers, withered branches and extra side branches on the plant to prevent them from consuming a lot of nutrients, and after pruning, it will be able to produce more and more beautiful flowers in the second year.
2. Reduce watering
The lily will become very fragile after flowering, so when it is pruned, it cannot be watered immediately, but the amount of water must be reduced, because it will slowly enter a dormant state after blooming, and it will no longer absorb water at this time. If there is too much water in the basin, it will let the roots rot, so its growth will be limited, and in serious cases, it will die. So be sure to control the amount of water.
3. Fertilizing and topdressing
After flowering, you must apply fertilizer and topdressing correctly. At flowering stage, you can apply compound fertilizer once a week, and the best time is once a week, and you can stop fertilizing after flowering, so that it can produce more beautiful flowers and prolong the florescence.
4. Keep warm in winter
After flowering, the temperature gradually drops, slowly ushered in the winter, it can adapt to the temperature is 16 to 24 degrees, must not be lower than 5 degrees, otherwise it will affect growth. So be sure to keep warm in winter, move it indoors, and keep the temperature above 10 degrees, so that it can survive the winter safely and blossom normally the following year.
- Prev
40 ℃ hot summer, these 4 points do not pay attention, the flower dies only the pot!
After Greater Heat, the temperature rose in a straight line, Huahua did not want to take a step out of the air-conditioned room. These days, Huahua has received a lot of messages from flower friends, basically all their own flowers are dead, do not want to grow flowers any more! In a hot day, it is difficult for people to endure, and flowers are even more difficult, but as long as you pay attention to these points, you can also grow flowers in summer!
- Next
Cutting Propagation of Pelargonium
The best time for cutting geraniums is May or October. Select the healthy cuttings and make sure there are 3 left and right leaf nodes on the top, then place them in the shade for 2 hours before cutting. Then select the matrix, fine yellow sand is the best. Finally, just insert the treated cuttings into the soil, then spray water properly and wait for the roots to take root.
Related
- What if the leaves of potted flowers turn yellow?
- Florescence Control of several Flowers
- Anti-freezing technology and post-freezing nursing technology of flowers
- What is the classification of flowers? What are the common methods of flower classification?
- Prevention and control of alkali and acid damage of flowers in courtyard
- Technology of Anti-freezing and restoring growth of Flower seedlings in greenhouse and greenhouse
- How does flower fertilization not hurt the root? Fertilization technology of flowers
- Key points of disinfection in flower greenhouse
- Several pesticides that are banned or used cautiously in flowers
- How to fertilize the flowers that watch the leaves?