If you spend money indiscriminately to raise these 10 kinds of flowers and leaves, you can burst a pot of cloning machine.
For those who like to grow flowers, here comes the welfare! Summer is the right season for plants to reproduce. The 10 kinds of flowers mentioned in the stone below have a strong ability to reproduce. As long as they pull a few leaves, they can grow to burst pots, and they can get 10 pots of good-looking flowers without spending a penny.
Cutting is the most important way of propagation for many plants, such as very popular succulent plants, which basically rely on cutting propagation to obtain more young plants. there are two reasons for choosing cutting propagation. First, cutting propagation will continue to maintain the characteristics of the mother plant on the daughter plant, and will not easily cause character changes and gene mutations. Second: if you use seeds to propagate, we all know that the quality of succulent seeds cannot be guaranteed, and "false seeds" are rampant in the flower market. Who can guarantee that what you plant is what you want? And succulent seed reproduction is prone to mutation, growing out of the "four not like"!
Therefore, it is still a relatively reliable way of plant reproduction to propagate flowers through cuttings. such as succulent, Yushu, tiger skin orchid, gardenia, camellia, longevity flowers, begonia, crab claw orchid, rubber tree, Qin leaf banyan are all through cutting propagation to achieve the cultivation of new plants, it is also a broad way of plant cloning! So if you want to raise the following 10 kinds of flowers, do not go to the flower market to "spend money", pull "a few leaves can burst out a pot, hurry up!"
1. air plant
Hearing the name: take root on the ground, yes, its leaves are "rooted on the ground." this is the succulent plant of crassulaceae. The edges of the leaves are covered with full-winged butterflies, also known as adventitious buds. With the growth of the leaves, many air roots grow at the bottom, and after withering and falling in the flowerpot, they will take root and grow into independent seedlings.
Cuttings take root on the ground, only 1 leaf can grow a pot of meat, the cutting method is very simple. Cut a leaf, put it flat in the flowerpot, choose the sterilized sand or special cutting substrate, put the air root side close to the ground, spray water to increase humidity, and put it in the shade indoors. About two weeks, all adventitious buds will grow into independent seedlings, and then continue to breed, which will soon burst the pot.
two。 Tiger Pilan
Whether it is tiger skin orchid or tiger tail orchid, it is only different in the shape and color of the leaves, and the cultivation of new seedlings can be realized through leaf insertion. Tiger skin orchid is a family flower widely loved by flower friends, and it is easy to raise and look good. It can not only afforest the living room and beautify the environment, but also absorb indoor formaldehyde, toluene and other harmful substances. Today, we are taught to breed a pot with a tiger skin orchid leaf. You don't have to buy anymore!
Cut the tiger skin orchid leaves from the mother plant and cut them into 10cm-long leaves with a blade. Pay attention to distinguish the upper and lower ends of the leaves, which can be marked with a marker. The upper and lower order planted in the soil will not grow new buds! Soak the lower end of the leaf in the aqueous solution of carbendazim of 1RV 500 for 10 minutes and then plant it into the sterilized moist cutting substrate and put it in a cool place for two weeks to see new buds.
Remember to disinfect the cuttings with carbendazim aqueous solution, otherwise the leaves will rot easily, not only will not sprout, but also all the leaves will rot; less watering during sprouting to ensure that the soil is slightly dry can promote the growth of new buds and roots. Three weeks later, the small buds grow up, transplant into a large pot for normal maintenance, and a pot of good-looking and healthy tiger Pilan will grow well.
3. Yushu
Yushu is also known in many places as thick-skinned, pig ears! No matter what you call it, it has a characteristic that a leaf can grow into a small plant, the speed is very fast! So flower friends who like Yushu can use leaves to breed Yushu without spending a penny.
Yushu cuttage is not fastidious, directly from the sows up and down the leaves, we should pay attention not to hurt the bud point, and then lay the leaves face up on the soil, do not care, about two weeks can see a small bud issued.
When the small buds grow to 1 cm high, a blade cuts off the mother leaves, leaving the seedlings to continue to grow in the basin. In about half a year, you can see that Yushu burst into the basin, and there are a lot of seedlings that can be dug out and cultivated separately.
4. Longevity flower
Longevity flower means longevity and health, and it is a kind of flower and foliage plant that many flower lovers must raise. Longevity flowers have a long flowering period in a year, basically blooming from December to August of the following year. This season is the right season for longevity flowers to breed. A pot of flowers can be produced with a few leaves.
Many people will think that longevity flowers can only be cut with branches, not leaves. How do you know if you don't try? Take the longevity flower leaves from the mother plant, soak them in carbendazim aqueous solution for 10 minutes, then take them out to dry. Place the leaf end buds on the soil surface, cover with a thin layer of sand, spray them in a cool place, and see new buds coming out for a week or so.
5. Crab claw orchid
Crab claw orchids bloom one after another from the winter every year, and it is the time of the Spring Festival when the flowers are in full bloom, adding a lot of happiness and happiness to the New year. Therefore, every autumn, many flower lovers buy crab claw orchids and wait for the Spring Festival to see the flowers bloom. In fact, the propagation of crab claw orchids with leaves is very simple, as long as a few leaves are put into a pot, and then the cuttings are trimmed and sprouted, and the pot will soon burst.
Cut the leaves of a crab claw orchid, cut them into nodes, disinfect them in carbendazim aqueous solution to dry, plant them in clean sand, pay attention to the direction of cutting, insert the lower end of leaf morphology into the soil, and you will see new buds at the top of the leaves in about two weeks.
6. Rubber tree
Rubber is a woody flower, tall and straight branches, fat leaves are very ornamental, suitable for display in the spacious living room, the appearance is very high! If you want to raise a rubber tree, you can send out a small plant with a single leaf.
Cut off the leaves of the rubber tree, trim the leaf tips to reduce nutrient consumption; disinfect the leaves, in the same way as the crab claw orchid, bury the bottom of the treated leaves under the sand and put them in a cool place, and they will take root and sprout for two weeks. When you grow up, you can transplant it into a flowerpot and raise it normally.
7. Begonia bulbosa
Begonia bulb and begonia belong to the same family and genus of flowers, are flowering plants with long flowering period, but the flowers of begonia are much larger than begonia, and the flower size is similar to that of rose, and the flowering begonia is very beautiful. If you like it, try to breed with a leaf.
To breed Begonia bulbosa, you need to cut off the leaves, soak them in the solution of rooting powder, take them out after ten minutes and put them in clean water. The water is not too deep, just go through the bottom of the leaves. Change the water once during the period, and after two weeks, you will find that the root system comes out, and then transplant it in the flowerpot.
8. Camellia
Camellia is very common in southern China, is a very popular flower, camellia fragrance and colorful, suitable for courtyard breeding! In order to make camellias blossom in beautiful colors, grafting and cutting methods are generally used in camellia propagation, which can be divided into leaf cutting method and branch cutting method.
The operation of camellia leaf insertion is simple. Cut off the leaves and be careful not to hurt the place where the buds grow at the bottom. After disinfection, the bud points are inserted into the substrate and placed in a cool place. The roots will be sent out in two weeks, and then transplant and manage after growing up.
9. Douban green
Douban green is also known as "smoker". If there is secondhand smoke at home, it is recommended to keep a pot of Douban green. Its fleshy leaves can absorb harmful substances such as nicotine and benzene, and can be put in front of the computer to protect against radiation. The method of reproduction is very simple, cutting a few leaves can grow a pot.
Douban green is easy to raise, reproduction is even easier, directly break off the leaves, put on the sand, watering and put in a cool place to maintain, after the root system will grow, after the growth of new buds, cut off the mother leaves, continue to breed, later can be split.
10. Ficus chinensis
Qin leaf banyan as a family foliage flower, huge leaves, it can be said that the leaf of Qin leaf banyan is larger than the face, tall and straight branches, suitable for raising in the spacious living room, is a very simple and atmospheric family flower.
The propagation of banyan leaves is generally in the way of cutting propagation, and small buds can be sent out in one piece, healthy leaves can be cut off, and the leaves will be cut into the water. After one month, roots will grow, and later transplanting to the soil can be cultivated.
10 kinds of common flowers, "pull" a leaf can burst the pot, like flower friends quickly try it! About the content of flower and leaf cutting, please like and follow it below, and learn to cut potted plants by yourself. Try these "cloning machines"!
I am the stone gardener, click to follow, the content you share every day will be the first time to let you see!
- Prev
The leaf spray of Yushu really deserves to grow into an emerald ball in January.
The leaves of "Yushu" sprayed "it" and grew into a "jadeite ball" in January, which really deserved it! Many flower friends like to raise jade trees, cut a branch can send a pot, a leaf can grow into a small plant, the breeding method is very simple, and then add.
- Next
Crab claw orchid likes sour and sweet once every 7 days to feed this kind of sugar, the new buds bloom continuously.
Crab claw orchid is a favorite green plant for many flower friends, with emerald green and thick stems and bright red flowers. It is a good ornamental plant for foliage and flowerpot planting. Some flower lovers only know that crab claw orchid likes sour. In fact, it also likes candy very much. It only takes 7 days.
Related
- Wuhan Hospital Iron Tree Blooming Result Was Instantly Frightened by the Gardener Master
- Which variety of camellia is the most fragrant and best? Which one do you like best?
- What is the small blue coat, the breeding methods and matters needing attention of the succulent plant
- Dormancy time and maintenance management of succulent plants during dormancy
- Minas succulent how to raise, Minas succulent plant pictures
- What are the varieties of winter succulent plants
- How to raise succulent plants in twelve rolls? let's take a look at some experience of breeding twelve rolls.
- Attention should be paid to water control for succulent plants during dormant period (winter and summer)
- Watering experience of twelve rolls of succulent plants
- Techniques for fertilizing succulent plants. An article will let you know how to fertilize succulent plants.