The succulent summer artifact can be done with a few wires, even saving the flowerpot.

Summer for succulent plant, is a ghost gate, summer maintenance is too troublesome, but also easy to die, is there any shortcut, easy to make succulent not to die? Yes, a few summer artifacts will be done!

Summer artifact-- Moon ship

What is a moon ship?

The moon boat is similar to a hollowed-out basket of flowers. After being woven, you can spread a layer of palm bark and raise succulent plants.

Both the moon boat and the palm bark are super breathable and permeable. You don't have to worry about watering too much in summer, and you don't have to worry about the impervious soil, which will lead to rotten roots and leaves.

Manufacturing method

1. Bend several thicker iron wires into two small and one large circles, which are wound and fixed with thin wire.

2. Bend the shorter wire to make a small decoration.

3. Fix the finished decoration on the large circle with thin wire.

4. Weave a network in a large circle with the thinnest wire, and a moon ship will be done!

5. Lay a layer of palm bark, grass mats, etc., on the moon ship, and then cover it with granular soil to grow flowers!

Summer artifact-extruded watering bottle

What is a squeeze watering bottle?

Meat grows slowly in summer, so we have to water or water too much at this time. Using a squeeze watering bottle and changing the water pressure can prevent the meat from rotting or dying of thirst!

Manufacturing method

1. Preparation materials: mineral water bottle, straw, screwdriver

2. Drilling: after heating the screwdriver on the gas stove, drill a hole in the bottle cap quickly, which is simple and labor-saving!

3. Cut the straw to the desired length and insert it into the hole.

If the bottle is filled with water, it can be used to water the flowers. Extruded watering bottle, watering position is easy to control, do not have to worry about sprinkling water on the leaves, thus burning the leaves, especially suitable for dense succulent leaves.

Leaf inserting artifact-water storage cup

What is a water storage cup?

When inserting leaves into the meat in summer, make a water storage cup with a mineral water bottle, which can keep the soil moist and greatly improve the survival rate.

Manufacturing method

1. Clean up the outside of the mineral water bottle, cut it at 1 / 2, and trim the edges neatly with scissors.

2. Draw an X-shaped crack in the bottle cap with a small eyebrow knife, and then wear a cotton thread, which is slightly longer than the upper part of the bottle.

3. After stringing the rope, screw on the bottle cap, and then put the upper and lower halves together to complete a water storage cup!

4. Fill the upper part with the medium, insert the leaves, and then water the leaves once to keep the amount of water below at about 1~2cm. After that, you can wait for rooting and no more watering!

Summer artifact-solar panel electric fan

What is a solar panel fan?

The combination of solar panels and electric fans, and then pull a layer of sunshade net, can protect against the sun, rain, ventilation, cooling, for succulent plants at one stroke!

Manufacturing method

1. Preparation materials: wire, solar panel, electric fan

2. Fix the solar panel on the flower rack of the balcony with iron wire, and then tie the rotatable fan on the flower rack and under the solar panel.

3. Turn on the fan switch, and the whole summer artifact begins to work: the fan is used for ventilation and cooling, the sunshade net can shade the sun and filter into scattered light, the solar panel can cool down, the temperature is 40 degrees, and the meat can live steadily!

Note: fan wires should be able to get sockets!

If flower friends find it troublesome, they don't have a lot of succulent plants at home. They can just turn on a fan or pull a sunshade net.

That's all for today.

What other succulent summer artifacts do you know?

Post the picture and share it with you!

?