How to use water to grow Agaricus bisporus?

How to use water to grow Agaricus bisporus? Please guide the production of Agaricus bisporus from covering soil to mushroom, in addition to doing a good job in routine water use and moisturizing management, correctly grasp and apply the following four key points of water use, it plays an important role in ensuring the quantity and vitality of mycelium, ensuring the consistency of budding quantity and budding, ensuring the healthy growth of fruiting body and its commodity quality. The bacteriological water should be timely. Spray pressurized bacterial water when hyphae appear on the bed. The method is: increase the ventilation rate, make the soil surface mycelium lodge; according to the soil layer bacteria situation to master spray water, generally about 1 kg per square meter of material surface, once in the morning and evening, half of the soil layer can be permeable. After spraying water, the hyphae no longer drill out of the soil surface, but should be combined with strong ventilation to make the top layer 0.5 cm thick soil surface dehydrated and slightly whitened, and the hyphae grow laterally, connect and reach physiological maturity in the soil layer below this thickness. Mushroom water should be re-sprayed. Mushroom water was sprayed after 3 days. According to the water content of the base material and the water content of the soil layer, it is sprayed four times according to the dosage of 3 kg per square meter, according to the moisture permeability of the overlying soil layer but no water seepage. Ventilation should be strengthened when spraying mushroom water, and forced ventilation measures should be taken if conditions permit. Small mushroom buds can be seen after 2-3 days. There should be enough water to produce mushrooms. The dosage and spraying method of mushroom water is similar to that of mushroom water. At this time, mushroom buds have appeared, we should pay attention to the water temperature as much as possible similar to the greenhouse temperature, the temperature difference should not be too large. Where there are mushroom buds, a small amount of water should be sprayed many times, the total amount should be sufficient, but to avoid water infiltration into the base material. Water should be maintained regularly. Combined with maintaining the humidity of the mushroom shed, it is necessary to grasp the water spraying times and water consumption according to the temperature, ventilation and other conditions every day, keep the air humidity about 90%, and the overlying soil surface is basically wet, but there is whitening at the ventilation hole and near the door. As the fruit body continues to grow, the number of water spraying and water consumption should also continue to increase. When the diameter of the cap is 1 cm, the three-dimensional nutrient essence solution of edible fungi can be sprayed directly, once a day in October and every other day after the middle of October, and spray water to the fruiting body according to the humidity in the shed. Click to get more mushroom planting techniques click to get more edible mushroom cultivation techniques