Planting techniques of cauliflower
Cauliflower is a perennial herb of the genus Hemerocallis in Liliaceae. it is cultivated in the north and south of China, mostly distributed in the south of Qinling Mountains, Hunan, Jiangsu, Zhejiang, Hubei, Jiangxi, Sichuan, Gansu, Shaanxi, Jilin, Guangdong and Inner Mongolia grasslands. Qu County of Sichuan is called "the hometown of Chinese yellow flowers". Let's take a look at the planting techniques of cauliflower.
Growth habits of cauliflower
Cauliflower is barren, drought-tolerant, lax on soil, and can be cultivated either geographically or on hillsides. It can adapt to a wide range of light and can be intercropped with taller crops. The aboveground part is not resistant to cold, and the underground part is resistant to-10 ℃ low temperature. Avoid wet soil or stagnant water. The seedlings began to be unearthed when the average temperature was more than 5 ℃, and the optimum temperature for leaf growth was 15-20 ℃. Higher temperature was required at flowering stage, and 20-25 ℃ was suitable.
Cultivated varieties of cauliflower
1. Precocious type: the precocious type of cauliflower includes April flower, May flower, early morning flower, early tea mountain flower and so on.
2. Medium-mature type: medium-mature cauliflower has short arrow mid-term flower, high arrow mid-term flower, Mengzi flower, white flower, eggplant flower, curd flower, long-handle flower, black flower and so on.
3. Late ripening type: the late ripening type of cauliflower includes inverted arrow flower, fine leaf flower, mid-autumn flower, big leaf flower and so on.
Propagation methods of cauliflower
1. Ramet: the ramet propagation of cauliflower is the most commonly used propagation method of cauliflower. One is to dig out all the mother clumps and replant them, and the other is to dig out part of the plants on one side of the mother clumps to make seedlings, leaving them to continue to grow. When digging and dividing seedlings, it is necessary to hurt the roots as little as possible, and then plant seedlings with digging and dividing seedlings.
2. Slicing: after the cauliflower is harvested, the root plant is dug up, and then separated according to the bud, remove the hairy leaves around the shortened stem, the dead leaves, then leave the leaf length of 3 to 5 cm, cut off the upper end, and then cut the rhizome longitudinally into two pieces from top to bottom with a knife, each seedling piece should be cut with seedling stem and whisker root at the bottom, and soak seeds with 1200 times solution of more than 50% carbendazim for 1 hour after cutting. After fishing out and drying, mix seeds with fine soil or plant ash mixed with loess to raise seedlings.
3. Cutting: after the harvest of cauliflower, the bracts are fresh green from the middle and upper parts of the flower, and the growing point under the bract is obvious. Cut it off about 15 cm above and below the growing point, and cut it into the soil in a slight arc, so that the upper and lower ends are buried in the soil, so that the part of the bract with growing point is exposed to the ground, slightly covered with fine soil protection, and can grow roots and buds after about 1 week. After 1 year of cultivation, there are 12 tillers per plant. At least 5 will blossom the following year.
4. Sowing: cauliflower was artificially pollinated 10-60 minutes after flowering. The fruit rate of the top branch and the second branch of the main inflorescence was the highest, and the fruiting rate of the first and second fruit nodes was the highest. For the first to the fourth branches, the buds on the first and second fruit nodes could be retained, and the buds on the first and second fruit nodes could be retained in the top branches of the main inflorescence, and the rest of the buds should be thinned to concentrate nutrients on the fruit and seeds.
Planting techniques of cauliflower
1. Reasonable close planting: close planting of cauliflower can give full play to population advantages, increase the number of tillers, bolting and buds, and achieve the purpose of increasing yield. Generally adopt wide and narrow row cultivation, wide row 60 cm 75 cm, narrow row 30 cm 45 cm, hole distance 9 cm 15 cm, planting 2 plants per hole, planting 45000 ~ 75000 plants per hectare, and the peak yield period reaches 1.5 million ~ 2.25 million plants / ha.
2. Appropriate deep planting: the root group of cauliflower grows from around the shortened stem, with one layer a year, and the root position moves up year by year from bottom to top, so proper deep planting is beneficial to plant survival and prosperity, and the suitable planting depth is 10-15 cm. Root water should be watered after planting, and the soil should always be kept moist before autumn seedlings grow, so as to facilitate the growth of new seedlings.
3. Cultivating soil in middle ploughing: cauliflower is a fleshy root system, which needs fertile and loose soil environmental conditions in order to be beneficial to the growth and development of the root group. During the growth period, intertillage should be carried out for 3 times according to the growth and soil consolidation, and the first time should be carried out when the seedlings are unearthed. The second to fourth times in the bolting stage combined with mid-tillage to cultivate the soil.
Fertilization management of cauliflower
1. Winter fertilizer: growth should be stopped in the upper part of cauliflower field, that is, autumn seedlings withered by frost or planted, mainly organic fertilizer, 30,000 kg / ha of high-quality farm manure and 750 kg / ha of calcium superphosphate.
2. Seedling fertilizer: seedling fertilizer is mainly used for seedling emergence and long leaves to promote the early growth and rapid development of leaves. Seedling fertilizer should be applied sooner rather than later, when cauliflower begins to sprout, calcium superphosphate 150 kg / ha and potassium sulfate 75 kg / ha.
3. Bolting fertilizer: cauliflower bolting period is an important period from vegetative growth to reproductive growth, which requires more fertilizer, which should be applied at the beginning of bolting, urea 225 kg / ha, calcium superphosphate 150 kg / ha, potassium sulfate 75 kg / ha.
4. Bud fertilizer: Bud fertilizer can prevent cauliflower from getting rid of fertilizer and early senescence, increase bud rate, prolong picking period and increase yield. Urea 75 kg / ha should be applied within 7-10 days after picking. At the same time, 0.2% potassium dihydrogen phosphate was sprayed on the leaves every 7 days or so, 0.4% urea, 1-2% calcium superphosphate aqueous solution, and 15020 mg / kg 920 was sprayed once after 17: 00, which had obvious effect on strengthening buds and preventing bud removal.
Disease and pest control of cauliflower
1. Rust
[harm] Rust is mainly harmful to leaves and flower stems, the initial infection produces blister spots, and then breaks through the epidermis and breaks out the yellowish-brown powder, that is, the summer spores of the pathogen, sometimes many blister spots merge into one, the epidermis is covered with yellowish-brown powdery summer spores, the leaves are often greenish and yellowish, the whole leaves turn yellow, in serious cases, the whole plant leaves die, the flower stems become reddish brown, and the buds shrivel or fall off.
[prevention and control] rational fertilization and timely drainage after rain to prevent stagnant water in the field or excessive surface humidity. After harvest, bolting and cutting leaves are concentrated and burned, and the soil is turned over in time, and the soil is loosened and weeded in early spring. In the early stage of the disease, 50% carbendazim wettable powder 600 times, 75% chlorothalonil 600 times, 50% Dysen zinc 500 times or 40% Daoxianjing 600 times were sprayed every 7 to 10 days for 2 times.
2. Leaf blight
[harm] the leaf blight is mainly harmful to the leaves, the initial infection shows pale round spots from the leaf tip, and then the edge of the leaf gradually expands downward and becomes yellowish brown and dry, and black mildew occurs in the diseased part when the humidity is high. The mycelium of the pathogen overwintered in the soil with the disease residue, and the spores produced in the second year were transmitted and infected by wind and rain. Warm and rainy conditions are favorable for the occurrence of diseases, such as weak plant growth, over-dense planting, low-lying terrain, poor drainage and so on.
[prevention and control] the equivalent 0.5-0.6% Bordeaux solution or the 800-fold solution of 75% chlorothalonil wettable powder is commonly used for foliar spray control. After the occurrence of the disease, it is sprayed once every 10 days, for a total of 2 times.
3. Leaf spot
[harm] Leaf spot is mainly harmful to leaves and bolts. The primary light yellow spot of the leaf, after expansion, showed an oval dark green spot, and finally developed into a fusiform or spindle-shaped spot, the edge was dark brown, the center changed from yellowish brown to grayish white, there was a yellow halo around the spot, and there was a pink mold layer on the back of the spot when the humidity was high. It is easy to break when it is dry, and the whole leaf turns yellow and withered when it is seriously ill. Flower bolts are susceptible, and the symptoms are similar to those of leaves. Sometimes multiple disease spots synthesize sunken disease areas more than 10 cm long, and there are often thick reddish mildew on the disease spots, which affect the growth and bud formation of flower bolts, while those with heavy ones break off and die.
[control] selection of disease-resistant varieties, reasonable fertilization to enhance plant disease resistance, timely removal of disease residues after picking, concentrated burning or deep burial. In the early stage of the disease, 1500 times of 50% carbendazim wettable powder, 40% polysulfide suspension or 36% methyl thiophanate suspension and 50% carbendazim wettable powder were sprayed every 7 to 10 days for 2 times.
4. Anthrax
[harm] anthracnose is mainly harmful leaves, from the leaf tip to dark green, and then dark yellow, and expand to the leaf base, the edge of the spot is brown, dense small black spots, and in severe cases, the leaves die. The pathogen overwintered on the diseased and disabled body and spread by Rain Water, which caused serious damage from May to June.
[prevention and treatment] in the early stage of the disease, spray 1purl 100 Bordeaux solution, 50% methyl topiramate or 50% carbendazim wettable powder 800 × 1000 times, 75% chlorothalonil wettable powder 600 × 800 times.
5. White silk disease
[harm] White silk disease is mainly at the base of leaf sheath near the ground, at the base of the whole plant or outer leaf, waterlogged brown disease begins to occur, then expands, slightly sunken, and the affected part is brown wet rot. A white silk-like substance is produced in the disease part, which spreads to the whole base, and even there is a white silk-like mildew layer in the nearby soil. When it is wet, it produces purple-yellow sclerotia, and then changes from tea-brown to black-brown, the size of rapeseed. The damaged leaves turned yellow and withered due to the obstruction of water and nutrient transport. The hyphae spread from the outer leaves to the inner leaves, and finally withered the whole plant.
[prevention and control] clear the garden after harvest to reduce the source of overwintering bacteria. In the early stage of the disease, 50% carbendazim 500 × 800 times or 70% topiramate 800 times 1000 times were sprayed every 7 to 10 days for 2 times.
6. Brown spot
[harm] Brown spot harms the leaves, the disease is initially watery, and then turns into a light yellow to yellowish brown spindle-shaped or long fusiform spot, with a very obvious reddish brown halo on the edge, and a dark green ring at the junction of the outer layer and the healthy part. The disease spot is slightly smaller than the leaf spot disease, generally 0.1 cm 0.2 cm × 0.5 cm 1.5 cm, sometimes the spot heals into an irregular shape, and in the later stage, there are dense small black spots in the center of the spot.
[prevention and treatment] at the initial stage of the disease, spray with 50% carbendazim wettable powder 800 × 800 liquid, 75% chlorothalonil wettable powder 600 × 800 liquid, 50% topiramate wettable powder 500 × 800 liquid.
7. Red Spider
[harm] Red spiders harm leaves, adults and nymphs gather on the back of leaves and suck plant sap. Grayish-white dots appeared at the victim site, and in severe cases, the whole leaf was gray-white, and finally withered.
[control] spray with 1500 times of 15% promethazine wettable powder or 73% of 2000 times of propargite.
8. Aphids
[harm] aphids mainly occur in May, first harm the leaves, gradually pierce and suck the juice on the flowers and buds, and the buds are thin and easy to fall off after being killed.
[prevention] spray with 1000-1500 times of Mala sulfur emulsion or dimethoate solution. Fresh chili pepper is ground and directly sprayed with water. Fresh cauliflower area, because fresh cauliflower is picked and sold directly every day, it is forbidden to use pesticide spraying to find aphids in flower buds, so biological control methods must be used.
Related
- A course of planting techniques and methods on how to grow carrots
- How to plant the latest tulips?
- Is it better to pick tea in the morning or in the afternoon? When is the best time for tea to be picked? what is the third or fifth tea?
- Launch Yuanxiao Happy combination Haocha + Tea Yuan healthy Taste
- Penghu Tourism "Fireworks 20 Parade with You"
- 2022 West Lake Happiness holds "Digital Revitalization Voucher" and draws iphone13 and laptop.
- Banqiao Fuzhou social houses are designed to change start-up combined with police elimination to create a safe and livable environment
- The convenient measure of "mechanical weeding" in Xinbei has been abused and the Agriculture Bureau has imposed heavy penalties on the illegal land consolidation.
- Changgeng University Joins Hands with Four Memory Factories to Rescue Memory Talent Shortage
- The list of Taiwan's top 100 MVP managers is listed by the Director-General of the Farmers' Association of Sanxia District.