MySheen

Succulent plant leaves have been unable to survive? It is difficult to estimate that this step is missing.

Published: 2024-11-22 Author: mysheen
Last Updated: 2024/11/22, In fact, succulent plants insert leaves, no matter how much you pay attention to details, but you do not find the right time, mistakenly thinking that spring or autumn is the best time, it is a big mistake, in fact, on the contrary, when leaves are at their best.

In fact, succulent plant leaf insertion, no matter how much you pay attention to details, but you did not find the right time, mistakenly think that spring or autumn is the best time, that can be a big mistake, in fact, on the contrary, the best time for leaf insertion is summer and winter, it is easier to root and sprout, where there is heating, winter is about the same as spring and autumn. The slowest season for leaf insertion is summer, which is not easy to sprout and easy to dissolve water. Sometimes succulent plants are planted in the best season, followed by an extremely bad weather, which tests the survival of succulent plants, some of which are solidified, even water black rot or stiff seedlings.

For the leaf insertion steps of succulent plants, the first step is to select healthy leaves, and then put the healthy leaves under scattered light to dry for 2-5 days to make the wound heal. During this process, the leaves may collapse or wrinkle slightly, but it doesn't matter if the leaves are healthy. The leaves will begin to sprout and root in the air. Leaf cuttings have requirements on the humidity of the basin soil, too wet leaves are easy to rot, completely dry is not conducive to rooting, and rooting is not conducive to root growth, so it can only slightly maintain relative moisture, especially in the topsoil. The topsoil is usually sprayed with a spray can before the leaves are inserted.

If it is in summer or winter, break off the leaves, put them in a very dry place, and wrap them in paper. Most people choose to put succulent plants on dry soil. In short, the environment needs to be dry, because you keep it a little longer, and then you wait for the next season and choose to plant leaves in the right season, which can improve the survival rate. When transplanting seedlings for succulent leaves, you should also pay attention to it, that is, try not to have light, ventilation is enough, if your leaves are really fat and full, you can try to give a little light, but there must be a ventilated environment.

Most of the 12-volume genera of Sedum and Liliaceae can be inserted into leaves. However, the survival rate of leaf insertion of individual varieties is very low, such as mages, Dongyun and ebony, as well as varieties with their genes. Because the leaf insert needs appropriate moisturizing, so it is recommended not to use red pottery basin, it is recommended to use plastic basin, iron basin. Flowerpots need water holes. The flat flowerpot is the best, and it is more space-saving to be carried out directly in the 7 cm high seedling plate. After the succulent leaves are placed, put the flowerpot in a ventilated and non-exposed environment, the soil becomes dry and then spray water, a small amount of sunshine and bright scattered light are the best (it is OK to bask hard through the glass below 20 degrees). During this period, the little guys often like water droplets ~ as long as they are not soaked in water.

There are many situations after succulent leaves are inserted and germinated, such as only sprouting and not rooting. Do not worry too much, equivalent to about 80% of the success, as long as the old leaves do not die, let the seedlings grow slowly, wait for a certain time, it will take root, just like broken branches, cutting is as simple. When it does not take root or sprout. That depends on the place where the matrix is broken, or with a layer of skin on the path, which can be pulled out gently, it will be easier to sprout, and all that is left is to wait quietly.

The seedlings that take root and sprout are very healthy, grow very big, and the maternal leaves are still very healthy. This is the most desired phenomenon, but also the best. When the seedling is more than two or three centimeters, you can try, gently shake the parent leaf, break it off slowly, so it is a new leaf, you can try to insert the leaf again and recycle it. Many people use spray cans to spray water on the leaves, which is very bad, so that the leaves are more likely to die. With maternal leaves constantly providing nutrition, the seedlings will grow healthier and grow much faster.

Here is a gathering place for succulent plant lovers, sharing succulent maintenance skills, welcome to follow and exchange.

 
0