MySheen

There is an ingenious way to grow flowers in the family to spray beer with sufficient nutrients on the surface of the leaves and bright leaves.

Published: 2024-11-22 Author: mysheen
Last Updated: 2024/11/22, Beer, which is common at home, is very easy to use. when drinking beer, a little bit is left over, diluted to wipe flowers, nourish leaves and make sure your potted plants are greener and brighter. Because most of the beer is brewed by grain, it is rich in a lot of.

Home common beer, but very easy to use, drink beer left, diluted to wipe flowers, to supplement nutrition leaves, ensure that your home potted more green oil bright. Because most beer is brewed from grain, it is rich in many vitamins B, amino acids, phosphates, sugars, proteins and other substances, which is conducive to the growth of flowers. And beer also contains a lot of carbon dioxide, carbon dioxide is essential for flower metabolism, so wipe the leaves with beer, can make the leaves more green oil bright!

Beer can also be used to water succulent plants, but pay attention to a lot, ordinary beer diluted with water, water ten, beer one, so you can rest assured that the fleshy spray leaves and irrigation roots, do not worry about hurting the fleshy. Remember not to water flowers directly with beer, but also remember not to dilute good beer, frequent watering of meat as fertilizer, easy to cause problems, in the growth period of succulent plants almost once every two months, twelve rolls and raw stone flowers and other succulent plants, also once every two months, can not be frequent.

If you want to wipe the leaves with beer at ordinary times, you must dilute the beer before using it. You can mix beer and water into a solution according to the ratio of 1:10. Use a clean soft cloth, dip it in beer solution, and gently wipe the leaves to achieve the effect of extra-root fertilization. This method applies to flowers with relatively large leaves, such as green radish, clivia, fortune tree, evergreen, etc.

You can choose a softer towel, and then sprinkle some water on it to make it slightly wet. Then hold the leaves of the plant in one hand and gently wipe them along the veins on the surface of the leaves with a towel in the other hand. Be careful not to use too much force to avoid damaging the cells inside the leaves. Choose a softer towel, and then sprinkle some water on it to make it slightly wet. Then hold the leaves of the plant in one hand and gently wipe them along the veins on the surface of the leaves with a towel in the other hand. Be careful not to use too much force to avoid damaging the cells inside the leaves.

Finally, mention succulent plants. Spring and autumn are the peak seasons for fleshy growth, so you can water them more. Winter and summer are the dormant periods of some fleshy varieties. You need to water them properly. In summer, you should avoid the high water temperature at noon. Succulent plants should not be poured directly on the leaves with water, especially when the temperature is high at noon. After the water is stored on the succulent leaves, the high temperature will burn the leaves.

If in winter, the water temperature must be relatively low if the tap water is directly connected. If the meat is directly poured, the meat will not stand the low temperature and wither. Therefore, the home must put a container for water storage. When the water temperature reaches room temperature, the meat will be poured. Most meat lovers like to collect rainwater to irrigate meat, you can do so, but only if you have a very good air environment, haze days rain is harmful oh.

This is a gathering place for succulent plant lovers to share succulent conservation skills. Welcome to pay attention to communication.

 
0