Discussion on Raw material loss in Feed Factory

Dear teachers, I have produced the material several times and found that the loss is very large. I would like to ask you, what is the range of raw material loss in the feed factory?-- our company produces fish feed, and the input-output ratio of the production department is generally maintained at about 98.50%. At 13:30 on 2009-11-27, there are several factors that have great influence on wear and tear: moisture of raw materials, impurities, storage time, production process, implementation of lean production, and so on. If we limit it to 0.2%, we should be able to do it. We reached 3%wangxiang213 in 2009-11-27 13:49 to add the following production of 30 tons of material, resulting in a loss of more than 1 ton of wangxiang213 at 2009-11-27 13:49 to add the following, I think The loss is a little high-- mainly the loss of moisture and ash. Including raw material inventory loss and production process loss. Our total wear and tear is about 2%. To avoid wear and tear, 1-1.5% water can be added to the mixer. -- what materials should be made clear? What kind of production process (manual or mechanical), you can test the moisture of the raw materials used. There is also the moisture of the finished product, and the moisture after mixing is tested. We will know which section has the greatest loss, so as to control it. -- what materials should be made clear? What kind of production process (manual or mechanical), you can test the moisture of the raw materials used. There is also the moisture of the finished product, and the moisture after mixing is tested. We will know which section has the greatest loss, so as to control it. -- Yes, do a good job in the control of every link in the production process, including warehouse management-- raw material moisture raw material turnover grinding fineness process parameters. Can affect the wear and tear-the sixth floor Yang has not seen for a long time, free more contact! In addition to the normal wear and tear, there is also the pipeline process. If the process is long and a little is left everywhere, there will be a lot of residue, and your measurement loss will be on the high side. Ours is similar to our brother on the second floor.