Design requirements of rabbit cage

Rabbit cage design requires that rabbit cage design should be low-cost, durable, easy to operate and manage, and meet the physiological requirements of meat rabbits. The design includes the specification, structure and overall height of the rabbit cage. (l) the size of rabbit cages should be determined according to the breed, type and age of meat rabbits. Generally speaking, the meat rabbit can move freely in the cage. The breeding cage should be larger than the commercial cage, and the indoor cage should be slightly smaller than the outdoor cage. General male, female and reserve breeding rabbits, each requires an area of 0. 5%. 25 to 0. 4 square meters, 0. 5% for fattening rabbits. 12 ~ 0. 15 square meters. (2) the ① cage wall of rabbit cage member can be made of brick or cement board, or nailed with bamboo or metal plate. In the use of brick or cement prefabricated parts, dung-bearing plates and cage soleplates must be reserved for shoulder rest, and the shoulder width should be 3-5 cm; bamboo, wood or metal lath should be used, with a width of 15-30 mm and a spacing of 15-20 mm. Cement preform is suitable for ② dung bearing plate, and the thickness is 2 ~ 2. Five centimeters. In a multi-layer rabbit cage, the upper dung-bearing plate is the top of the lower rabbit cage. in order to prevent the upper rabbit cage from splashing the dung and urine and sewage of the lower rabbit cage, the dung-bearing plate should extend 3-5 cm to the front of the cage and 5-10 cm behind. In the design and installation, it is necessary to have a certain inclination, and the tilt angle is about 150, so that the feces and urine can automatically fall into the ditch through the plate, and is convenient for cleaning. The bottom plate of ③ cage is generally made of bamboo or galvanized cold-drawn steel wire. For the movable cage floor nailed with bamboo, the bamboo should be smooth and 2. 5% wide. 2 ~ 2. 5 cm, 0. 5% thick. 7 ~ 0. 8 cm, the distance between bamboo slices is 1-1. 2 cm, the direction of bamboo nailing should be perpendicular to the cage door to prevent the rabbit's feet from paddling to both sides. The rabbit cage made of galvanized cold-drawn steel wire has a welded mesh size of 50 mm × 13 mm or 75 mm x 13 mm with a diameter of 1. 8 ~ 2. 4mm; such as plated plasticized cold-drawn steel wire or nylon cold-drawn steel wire has a better effect, the net bottom is relatively firm, not easy to damage. ④ cage door is generally installed in front of the cage and can be made of bamboo sheet, piercing iron sheet and galvanized cold-drawn steel wire. it is required to open and close conveniently, the inside is smooth, and can defend against animal damage. (3) the overall height is convenient for operation, management and maintenance, the total height of the rabbit cage should be less than 2 meters, and the off-ground height of the bottom rabbit cage should be more than 25 cm, so as to facilitate ventilation and moisture protection, and make the bottom rabbit have a better living environment. Liuzhou City is developing the scale of raising rabbits, and the post provided by the landlord is just useful, thank you! -- how to solve the problem of selling rabbits? Building owner