Want to change a pot of incense into two pots? The cuttings are luxuriant and green in this way.

Vanilla such as touching incense has long been familiar to people, which is not only of high ornamental value, but also appreciated by plant lovers for its role in repelling mosquitoes and purifying the air. Touching incense is easy to raise and easy to reproduce. The main propagation method of touching incense is cutting. do friends want to have more incense? The method of cutting is very simple, as soon as you look at it!

How to cut incense

1. Cutting season

Friends need to pay attention to the time of cutting, touch incense can not bear the cold, so do not cut in winter, the survival rate will be very low, spring, summer and autumn can be cut.

2. Cutting methods

Choose some good-growing, green and healthy branches and buds, cut them from the bottom, and be careful not to damage the stalks. Leave them in a ventilated and cool place for a week, and you can see that the incision is healing. Then put the cuttings in the sand or in the sterilized soil with high perlite content, and remember to wet the soil surface before cutting, so that it is easier to cut.

Third, maintenance after cutting

After touching incense cuttings, pour the water thoroughly and place it in a ventilated and cool place. After that, stop watering. If the soil is too dry, steam can be sprayed around to increase air humidity. It will not be watered until two weeks later. After more than ten days, roots will grow, and in half a month or so, new leaves will grow. Then take good care of it and you will be able to develop a big one.

So, is the cutting method very simple? Have you learned it, buddy? After learning the cutting method, we will introduce to you the pruning method of touch incense, which will make your touch incense more exquisite and beautiful, more ornamental!

The pruning method of touching incense

A new seedling that has just been planted for a year does not need to be pruned, until a section of its bottom root grows in the second year, and it can be cut off after the old pile. If the breeding time is relatively long, you can carry out "beheading" pruning, that is, cut off the upper part, do not need too much, the cut part can also be used for cutting, cultivate new pots.

Post-shear maintenance

After trimming, the incense should be placed quietly in the room for a few days, and after the cut heals and dries slightly, it can be placed in the sun and pay attention to control the watering times. Touch incense in the sun to apply the right amount of potash fertilizer, so that its leaves are not easy to be tanned, continue to keep green and full!

All right, that's all for today's introduction, thank you for reading!