Now cutting these kinds of flowers will cover the garden in a few months.

Prepare for cuttage

Many flower friends have a special fondness for the rich tree that is pleasing to the eye and the rubber tree of the prosperous family.

The editor is one of them.

It is now early July, and the temperature in some parts of the country is basically maintained between 25 and 30 degrees, which is the suitable time for the cutting of these two kinds of plants.

So, let's share the cuttings of wealth tree and rubber tree.

Cutting method of rich tree

1. Prepare sufficient and clean river sand or vermiculite as cutting medium.

2. Disinfect the knife with alcohol or potassium permanganate solution and cut the cuttings.

3. What we need is one-year-old sturdy branches, with the best semi-Lignification and a truncated length of 15cm or a little shorter.

4. Quickly cut into a horseshoe-shaped incision, which is beneficial to the healing of cuttings.

5. Remove the leaves to reduce consumption and improve the survival rate, leaving only two old leaves and new leaves at the top.

6. Smear the incision with rooting agent, or wash it after soaking in the rooting solution for half a day, insert it into the prepared medium and pour it thoroughly.

7. Put it in a shaded and ventilated place and keep the temperature around 23 to 25. If you evaporate quickly, spray water sooner or later and keep it moist.

In general, less than a month after half a month, the wealth tree begins to take root. It is recommended to transplant to loose, fertile and well-drained potted soil two months later.

Cutting method of rubber tree

1. Select annual semi-lignified branches as cuttings. It is easy to rot and get sick if you are too young, but not easy to take root if you are too old.

2. Use sterilized scissors, cut off the branches, then apply cooked lime or gypsum powder to press the wound for 3 minutes, or scald the wound in boiling water until no white liquid flows out.

3. Remove the excess leaves and leave two pieces left. insert the leaves into the water bottle and change the water every 4 days. Spray water to cool and humidify every day to ensure sufficient light. It takes about 10 days to take root.

4. Transplant the cuttings that take root about 5mm to the river sand or vermiculite that is moisturized by spraying water in advance, and keep moist sooner or later.

5. In about two weeks, it can be transplanted to loose and drained soil to root and maintain in a warm, moist and bright astigmatism position.

The leaf insertion of a rubber tree

1. The terminal bud with leaf bud or tree at the base must be selected in order to grow into a new plant.

2. Cut off half of the leaves to reduce evaporation, and smear rooting powder at the base.

3. Insert the leaves into the pre-wetting vermiculite or river sand medium, expose the bud tip deeply, keep the temperature between 18 and 25 degrees, maintain a certain humidity and bright astigmatism.

4, after January, check the root system, if the root system is developed, it can be transplanted to the basin soil to take the basin, and then it can be maintained normally.