Architectural layout of Rabbit Farm

Environmental parameters of cage building

The suitable temperature of the rabbit house is 5-30 ℃, the optimum temperature is 15-25 ℃, the relative humidity is 60% MUI 65%, the lighting coefficient is 1:10, and the air flow speed is 0.2-0.25m / s.

Construction requirements of rabbit house

Rex rabbit breeding farm and large-scale commercial farm should set up production area, living area, office area and veterinary isolation area. Professional Rex rabbit farmers leave a certain distance between the rabbit house and the house. The rabbit houses are arranged in the north-south direction, with a distance of 3-4 meters from the house, a disinfection pool in front of each house, 1.2-1.5 meters of sidewalk and 0.6 meters of ditch. The site shall be subject to the following conditions:

1. Topography: slightly higher, flat, well drained, leeward facing the sun, avoiding direct sun exposure in summer and cold wind blowing directly in winter to keep warm in winter and cool in summer, with the rabbit house facing north and south.

2. Geographical location: the rabbit house should be built in a place with convenient transportation, sufficient electric power, good water source, far away from the main traffic line and living in downtown areas, so as to avoid noise interference and environmental pollution as far as possible.

Cage building and equipment

The use of face-to-face rabbit cage, every interval of 5-6 rabbit cage into the zigzag roof truss, the lower edge of the roof truss not less than 2.5-2.8 meters from the ground, the roof can be covered with wheat straw or small green tiles. For details, see the layout plan of the semi-open rabbit cage and the construction mode of the rabbit house, as shown in the figure:

1. The appearance and effect of the rabbit house (double row)

Appearance of rabbit house

2. The plan of double arrangement of rabbit cage

Double arrangement plan of rabbit cage

3. The specifications and dimensions of rabbit cage components are shown as follows (in centimeters)

① dung bearing plate with a thickness of 2.2cm.

Fecal plate

② middle and lower cage side plates with a thickness of 2.4cm.

Middle and lower cage side plate

③ upper cage side plate, 2.4cm thick.

Upper cage side plate

④ middle and lower cage rear baffle, plate thickness 2.2cm.

Middle and lower cage rear baffle

⑤ upper cage rear bezel, plate thickness 2.2cm.

Upper cage rear bezel

⑥ upper cage roof, plate thickness 2.2cm.

Upper cage roof

⑦ rabbit cage side plate base, plate thickness 7 cm.

Base of rabbit cage side plate

⑧ rabbit cage bottom side plate base, plate thickness 7 cm.

The base of the side plate of the rabbit cage