Rose planting techniques

I. selection of land and land preparation

It is appropriate to choose sunny, fertile and loose loam or sandy loam with good drainage. Before ploughing, compost 2500~3000kg was applied per mu, 20~25cm was turned deeply, rake fine and leveled, and a high border was made, 1.5m wide and about 15cm high, and 30cm drains were dug on both sides.

2. Planting

On the finished border surface, the row spacing is 1.3m, the plant spacing is 1m, the hole depth is 40~50cm, and the hole diameter is 50~60cm. Dig loose the lower hard soil, apply appropriate amount of barnyard manure and cake fertilizer as base fertilizer, and then cover the soil 5~10cm. Then plant the seedling into the hole, put the root system around, make it stretch, cover the dry loose and crushed soil, and keep your feet firm when filling in the middle. After filling the soil, compaction again, the planting depth is slightly deeper than the original soil mark. Do not rake flat surface, to leave a shallow pit, in order to store water, and finally pour through the fixed root water, cover a layer of thin soil.

After the new buds germinated in early spring to March, the seedlings should be transplanted with soil masses, which should not be carried out too late, otherwise it would not be easy to survive. If the seedlings were transplanted from defoliation to germination in the next spring, the seedlings could be excavated with bare roots without soil balls, but the length of lateral roots should not be less than 20cm, otherwise it would not be easy to survive.