Main Points of Cutting of Phloea rotundifolia

Tripterygium rotundifolia is native to the Pacific Islands, and it is not difficult to cultivate it artificially. Because of its bright and changeable leaves, it has become a very popular foliage plant in recent years. Artificial propagation of Fulutong can use the method of cutting, the editor will give you a brief introduction.

Artemisia angustifolia

1-2-year-old branches can be cut for cuttage in the propagation of round-leaf flutunium. The selectivity of cultivated soil is not strict and the drainage is good. It can be carried out in both spring and autumn, but the effect of spring planting is better. Between March and April, 10-15 cm leaves can be cut, leaving only 2-3 leaves at the end, and the lower incision should be located at 0 below the node. 2 cm, and soak in 500ppm indolebutyric acid or No. 1 ABT rooting solution for 10 seconds, and then insert it into the sand bed or vermiculite. A small amount of cuttings can be made with vermiculite in a wide-mouth flowerpot. After pouring through water, it can be covered with plastic film to moisturize, maintain the proper temperature for rooting at 25: 30 ℃, and take root in 40% 50% shading at 20: 30 days. Cuttings germinate new buds and then transplant them into pots.

From May to June, the sturdy stem was selected and peeled 20 to 25 centimeters from the top. The peeling width was about 2 to 3 times of the stem diameter. The peat or mud bitter medicine was used to wrap the ring peeling place and knead it into a soil mass. The plastic film was used to wrap it tightly, and the water port was left at the top. If the stem is thin and can not support the soil mass, you can insert a bamboo pole as a support, tie the soil mass to the bamboo pole, and always keep the soil mass moist, and it can take root after 2 months. You can also go to the flower market to buy woody stems specially for cuttings for cutting, and it is easy to survive.

Is it poisonous? cuttage techniques of Fulu paulownia

The round leaf Fulu paulownia plant is much branched, the stem is tall and straight, the leaf is bright and changeable, and the umbel is paniculate. Is the round leaf flutong poisonous? How to reproduce? What are the main points of cultivation? Let's learn about it next.

Is round-leaf flutong poisonous?

Round-leaf flutong is not poisonous and can be raised in the bedroom. Fulutong can be kept in brightly lit places for a long time in the family, and it will grow more vigorously if you can see hours of sunshine indoors every day. Pay attention to avoid the direct sunlight outside in summer. During the growing period, Flutong kept the basin soil moist without stagnant water, and often sprayed the plant with water close to room temperature to increase air humidity and make the leaf color fresh.

2. Cuttage propagation of Fulu paulownia

The propagation of D. rotundifolia can cut 1-2-year-old branches for cutting, the cuttings are about 10 cm long, remove most of the leaves to reduce evaporation, maintain high air humidity under the condition of 20 ℃ to 25 ℃, and take root in 4 to 6 weeks. Can also go to the flower market to buy woody stems for cutting, but also easy to survive. Round leaf Fulu Tong stem straight and straight, bright and changeable leaves, is a foliage plant, can use different specifications of plants to decorate the living room, bedroom, study, balcony and other places, both fashionable and elegant, but also natural and fresh.

Third, the main points of cultivation of Fulu tree with round leaf.

The cultivated soil is the best in fertile sandy loam, full sunshine and half-day sunshine of round-leaf Fulutong and palm-split Fulutong, and sufficient light of White Pearl Fulutong and Golden fern Fulutong. Fertilization is applied once every two months from spring to summer. Pruning in spring. Sexual preference for high temperature and humidity, drought tolerance, the suitable temperature for growth is about 20-30 ℃.

The above is the introduction of poisonous and cuttage propagation of round-leaf flutung, round-leaf flutung is non-toxic, so we can rest assured of pot culture, hope to help you.

Breeding management of Fulutong (scientific name: Polyscias guifoylei Bailey) also known as round-leaf Nanyansen, round-leaf Nanyang ginseng, is an evergreen shrub of Acanthopanax senticosus. Native to the Pacific islands. The plant height is 1 to 3 meters, the lateral branches are slender, and the branch lenticels are obvious. Leaves alternate, odd-pinnate, leaflets 3-4 pairs, opposite, elliptic or long elliptic, serrated margin, leaf green often with white spots, scattered inflorescences, flowers small. Pale green is mainly for potted plants, garden trees and hedges. Contact with its juice may cause a rash; when touching the mouth, it sometimes causes swelling and pain and is unable to swallow.

Breeding method: cutting can be carried out in both spring and autumn, but the effect of spring cutting is better. Between March and April, 10-15 cm leaves can be cut, leaving only 2-3 leaves at the end, and the lower incision should be located at 0.2cm below the node. Soak in 500ppm's indolebutyric acid or No. 1 ABT rooting solution for 10 seconds, and then insert it into the sand bed or vermiculite. A small amount of cuttings can be made with vermiculite in a wide-mouth flowerpot. After pouring through water, it can be covered with plastic film to moisturize, maintain the proper temperature for rooting at 25: 30 ℃, and take root in 40% 50% shading at 20: 30 days. Cuttings germinate new buds and then transplant them into pots. From May to June, the sturdy stem was selected and the peeling width was about 2-3 times of the stem diameter. The peat or mud bitter medicine was used to wrap the ring-shaped peeling place and knead it into a lump. Wrap it tightly with plastic film for external use, and leave a good water connection at the upper end. If the stem is thin and can not support the soil mass, you can insert a bamboo pole as a support, tie the soil mass to the bamboo pole, and always keep the soil mass moist, and it can take root after 2 months. The clustered plants planted in the ground can also be cultured under low pressure. Cultivation points: it likes high-temperature environment, not very cold-resistant; requires bright light, but also more resistant to shade, avoid sun exposure; like moist, but also more resistant to drought, but avoid wet water. The near temperature of its growth is 15: 30 ℃, in which it can be maintained at 20: 30 ℃ from April to October and at 13: 20 ℃ from October to April of the following year. Beautiful plants are usually more delicate, and so is Fulutong. Its variegated varieties are less resistant to cold. In general, even pure green leaf varieties should maintain a room temperature of no less than 10 ℃ in winter. When the summer temperature is more than 32 ℃, it can not be ignored, mass production should build a shed for shade, family viewing should be placed in a shady place, and water should be sprayed around to cool it, so as to create a cool small environment close to the original conditions. In late autumn and early winter, when the temperature drops to 15 ℃, it should be moved indoors in time to avoid cold damage. If the room temperature can be maintained more than 20 ℃ in winter, the stems and leaves will continue to grow; if the temperature is not high, the plant will stop growing and enter a semi-dormant state. Light to round leaf Fulutong, for example, it needs bright light, lack of light can easily cause long stems and leaves, dim leaves, faded markings, but at the same time avoid strong light exposure, especially after a long rain in early summer, to prevent leaves from being burned. Family potted plants can be placed in a well-ventilated place near the south entrance, north or east windows in summer, and indoor light in winter. For productive cultivation, from mid-spring to the Mid-Autumn Festival, should be placed in the shade, according to the intensity of light and the length of light, shading 40% 60%. In short, it grows most vigorously in an environment with half-light and bright scattered light. Water potted Fulutong likes wetter soil and air environment. During the growing period, there should be sufficient water supply, and then watering the surface of the basin soil after drying, the soil should be slightly dry, but it should not be watered too much to avoid causing stagnant water and rotting roots. The temperature is high in midsummer, in addition to sufficient watering, it is necessary to spray water on the leaf surface once a day, which can not only make the leaf surface clean and bright, but also improve the air humidity around the plant. In late autumn and early winter, when the temperature drops below 15 ℃, watering should be controlled. In winter, the amount of boiling water should be reduced, or water spraying should be used instead of watering, and the basin soil should be kept slightly moist and slightly dry, but when spraying foliage, we should pay attention to make the water temperature basically consistent with room temperature. The best soil is loose, fertile and well-drained sandy loam, which provides a loose, moist and fertile soil environment. Pot soil can be mixed with 4 parts of rotten leaf soil, 4 parts of garden soil, 2 parts of sand and a small amount of retted cake fertilizer or bone powder. The growing season can be combined with fertilization to loosen the soil once a month to keep the basin soil permeable for a long time and avoid rotting roots caused by the consolidation of the basin soil. Open field or shade under the plant, in the plum rainy season or encounter continuous rainy weather, should strengthen the inspection, found that there is stagnant water in the basin, should be promptly poured out and turned to change the soil, so as to avoid falling leaves or rotting roots. In general, the soil is changed once every two years in the spring. Fertilizing round leaves, flutong, etc., requires adequate fertilizer. In the period of vigorous growth from April to June, thin cake fertilizer can be irrigated once a month, or low concentration of poultry fertilizer can be used, but organic fertilizer can not be attached to the leaves. The fertilization time can be arranged after loosening the soil and pruning or before the rain, and it is best to sprinkle the foliage with water after pouring organic fertilizer. A mixture of 0.2% urea and 0.1% potassium dihydrogen phosphate can be irrigated in a family pot plant, or a small amount of multi-component slow-release compound fertilizer particles can be scattered or buried on the surface of the potted soil. Stop applying nitrogen fertilizer after the Mid-Autumn Festival and topdressing phosphorus and potassium fertilizer twice to increase the cold resistance of the plant and make it survive the winter smoothly. After the beginning of winter, the plant has stopped growing and should stop fertilizing so as not to hurt the roots.