Sowing of the propagation method of drunken butterfly flower

Drunken butterfly flower

Tall and straight drunken butterfly flowers have long petals, charming colors and colorful flower postures. Because of good management, there is no wild drunken butterfly flower in China. If florists like it, they can buy potted flowers and grow them back in the flower market. Of course, you can also buy seeds for cultivation.

Sowing and propagation of drunken butterfly flower

1. Matrix disinfection

The best way to disinfect the substrate used for sowing is to stir-fry it in a pan so that any diseases and insects can be scalded to death.

two。 Sprout

Soak the seeds in warm water of 25 degrees Celsius at 30 degrees Celsius for 3 to 10 hours until the seeds absorb water and swell up.

3. Sowing seeds

For tiny seeds that are difficult to pick up with hands or other tools, wet one end of the toothpick with water, stick the seeds one by one on the surface of the matrix, cover the matrix 1 cm thick, and then put the seeding flowerpot into the water. the depth of the water is 1 inch 2pm 3 of the height of the flowerpot, allowing the water to soak up slowly (this method is called "pot immersion").

For larger seeds that can be picked up by hand or other tools, put the seeds directly into the substrate and order them at a distance of 3 × 3 cm. After sowing, the substrate was covered, and the thickness of the cover was 2-3 times that of the seed. After sowing, you can use sprayers and fine-hole showers to wet the sowing matrix, and later, when the basin soil is slightly dry, you should still pay attention to the watering strength not to wash the seeds up.

4. Management after sowing

After the seedlings are unearthed after sowing, the film should be opened in time, and the seedlings should be exposed to the sun before 9:30 every morning or after 3:30 in the afternoon, otherwise the seedlings will grow very weakly; after most of the seeds come out, you need to plant seedlings properly: pull out the diseased and unhealthy seedlings so that there is some space between the seedlings left behind. When most of the seedlings have three or more leaves, they can be transplanted into the pot.

How to reproduce, sow and cut the drunken butterfly flower

How to reproduce the drunken butterfly flower can generally be propagated by sowing and cutting. both propagation methods can be used. Flower friends can choose the appropriate breeding method according to their own conditions. The following are sorted out the cutting and sowing propagation methods of drunken butterfly flower respectively. Easy for flower friends to consult.

How to reproduce drunken butterfly flower 1. Sowing and breeding methods

The sowing time of drunken butterfly flower is usually carried out in mid-April.

The Prime Minister sowed the seeds of the drunken butterfly on the open-field seedbed and sprouted neatly. Generally, the seedlings of drunken butterfly flowers grow slowly and need time after sowing. They are transplanted when they have 2-3 true leaves, planted in June or potted.

The drunken butterfly flower is fertilized once a half month during the growing period. for example, if the plant is fertilized too much, it is easy to grow and affect the plant state and flowering. generally, the spring sower blossoms in autumn and the autumn sower watches the flowers indoors in winter and spring.

2. Cutting propagation method.

First of all, prepare the nutrient soil or river sand, peat soil and branches and other materials for drunken butterfly cuttings, and then insert the drunken butterfly into the prepared potted soil.

Generally, the optimum temperature for drunken butterfly cuttings to take root is 18: 25 ℃, which is lower than 18 ℃. The relative humidity of the air must be kept at 75% 85%. The humidity can be increased by spraying the cuttings. At the same time, the sun must be covered by 50% to 80%. After the root system grows, the shading net is gradually removed.

How to sow drunken butterfly flower, how to plant drunken butterfly seed

Drunken butterfly generally use seed sowing methods to reproduce, so how to sow drunken butterfly, flower friends should first prepare drunken butterfly planting materials in advance, including seeds, soil, flowerpots, etc., and sort out the seed planting methods and steps below.

Seed planting method of drunken butterfly flower 1. Pot soil preparation

Drunken butterfly planting soil, need to be disinfected before use, you can generally put the pot soil into the pot to stir-fry, so that any diseases and insects can be scalded to death.

The materials needed for sowing substrate are peat and perlite. Perlite should be soaked in water before use. Mix imported peat and perlite at the ratio of 7:3, spray water to wet the substrate, and then stir evenly to ensure that the sowing substrate is loose and breathable.

2. Sowing and planting methods

For small seeds that are difficult to pick up with hands or other tools, wet one end of the toothpick with water, stick the seeds one by one on the surface of the matrix, cover the substrate 1 cm thick, and then put the seeding flowerpot into the water. the depth of the water is 1 foot 2 feet 2 tap 3 of the height of the flowerpot, allowing the water to soak up slowly (this method is called "pot immersion").

For larger seeds that can be picked up by hand or other tools, put the seeds directly into the substrate and order them at a distance of 3 × 3 cm. After sowing, the substrate was covered, and the thickness of the cover was 2-3 times that of the seed. After sowing, you can use sprayers and fine-hole showers to wet the sowing matrix, and later, when the basin soil is slightly dry, you should still pay attention to the watering strength not to wash the seeds up.

3. Management after sowing

The drunken butterfly flower shows white about a week after sowing, that is, the radicle breaks through the seed coat. Seeds need to be watered thoroughly after whitening. The best time to apply fertilizer is to apply fertilizer every other time, that is, after each watering, wait for the substrate to dry slightly, and then apply fertilizer. The water-soluble compound fertilizer with the ratio of nitrogen, phosphorus and potassium at 14:0:14 and the water-soluble compound fertilizer with the ratio of nitrogen, phosphorus and potassium at 20:10:20 were applied alternately, and the fertilizer concentration was 100PPM.

After sowing, the seedlings should be unearthed in time, and the seedlings should be exposed to the sun before 9:30 in the morning or after 3:30 in the afternoon, otherwise the seedlings will grow very weakly.

After most of the seeds come out, they need to plant seedlings properly: pull out the diseased and unhealthy seedlings, so that the seedlings left behind have a certain space between each other; when most of the seedlings grow 3 or more leaves, they can be transplanted into the pot.

When the seedlings grow 2 true leaves, they should be planted separately according to the plant distance of about 10 cm. When the seedlings grow to about 5 cm, they are planted in the garden with a row spacing of 30 cm ~ 40 cm.