After two weeks of such care, the rose after full bloom is in full bloom again.

In the last month, many flower friends should have seen the rose blossoms in the community, parks and green belts. Of course, those who raise rose can realize it even more.

It is true that the rose florescence is long and lasts all summer and autumn, but the methods and skills of breeding are particularly important. Today, the stone will share with you that after the full bloom of the rose: the full bloom can be achieved through reasonable pruning and fertilization.

Pruning methods of rose flowers after flowering

1. Pruning time:

The main purpose of post-pruning of rose flowers is to observe that after the flowers bloom or fail, the state shown in the picture above can be trimmed! It is suggested that you must not be reluctant to give up, for woody flowers such as rose must be pruned in order to promote the development and growth of lateral buds, and then grow new buds from the branches of lateral buds!

two。 Pruning method:

Rose pruning is very simple, but it is also very fastidious, which is divided into the following two kinds of pruning methods:

1. Single-headed variety

The so-called single-headed variety is a flower blooming on a branch, and the general branch is also relatively stout. When pruning, you can re-cut, cut off nearly five leaves from the bud, and the lateral buds will grow again two weeks later.

Chinese rose leaves have five leaves on a petiole, and the first or second leaves under the rose will be three leaves. Five leaves on a petiole show that the nutrients are more sufficient, and the corresponding bud points are also more nutritious.

2. Long-headed rose, open in different periods

The so-called long-headed variety means that there are several flowers on a branch. In such a plant, the main flower that is about to fail will be cut off and the other buds will bloom normally before pruning.

3. The long rose opens at the same time.

For those with many buds on a branch and blooming at the same time, prune them uniformly after flowering. Strong branches, leave 3-4 leaves, the upper part is all cut off, the medium branches retain only 2-3 leaves, the upper part is all cut off. On the other hand, the weaker branches are strongly cut, leaving only 1-2 bud points to promote the germination of robust branches.

Warm Tip: when pruning the rose, we must pay attention to the direction of the bud point and try to preserve the external bud point, so that the branches grow neatly, the lighting is uniform, and the ventilation of the whole plant is good, otherwise it grows out of staggered branches, which is not conducive to the plant type. it is also easy to cause poor ventilation and easy to get sick. The direction and height of the cut is also very important. When pruning, the direction of the cut is opposite to the direction of the bud point, cut at 0.5-0.8 above the bud point. The cut can be made into a flat cut or slightly inclined.

Fertilization method after flowering of rose

For rose, it is very necessary to fertilize and fertilize after pruning, because after the first wave of flowers bloom, the nutrition of the plant has been consumed a lot, and this is also the time for the development of new flower buds. It is recommended that we use potassium dihydrogen phosphate to promote the development of plant roots and provide sufficient nutrients for the development of flower buds. Do not use nitrogen fertilizer, this effect is counterproductive, will burn flower buds, resulting in rose can not blossom.