The longevity flowers don't bloom for a long time? With such a pruning, the basin is full of rubbing.

When we buy flowers in the flower market, the most common flowers should be longevity flowers, not only because their flowers are lovely, but also because their leaves are very likable. And if properly maintained, it can blossom several times a year.

In the process of raising, some people will feel very strange, why their own plants, thick green leaves, but have not blossomed, in fact, this is probably because you missed this step of pruning, do not just cut a little because you are reluctant to give up, after all, you have to give up!

We usually cut according to the overall height of the plant, the cutting position should be about 2 cm above the bud point, and pay attention to oblique shearing, which is not only conducive to wound healing, but also promote the growth of new flower branches. Never cut under the bud point or in the middle of the flower branch, or this branch may be useless!

In addition, we can cut according to our own preferences, but the effect is not scattered, but from a distance like a "ball", just hugging each other, so that when its new leaves and flowers grow out, we will feel more beautiful.

And after the flowers have failed, especially in this hot season, you can cut it down a little bit and don't have to stay too long. Because it will soon enter the dormant period, so it can retain the nutrition, in order to blossom smoothly next time.

In fact, if we want the longevity flower to blossom smoothly, in addition to pruning, we should also provide it with a certain amount of light, so that it can grow more symmetrically. In addition, during this period of dormancy, we must reduce watering, otherwise it will cause rotten roots and fallen leaves.

When we are pruning longevity flowers, we can cut the leaves and branches up. In fact, the operation steps of these two methods are basically the same, but the survival rate of cutting is relatively higher, and the rooting speed is faster, so the flower friends who cut leaves should not be in a hurry and often pull out the leaves to see if they have long roots.

When cutting, we have to choose the right branch, then cut it off with scissors, the branch should be stronger, do not use the kind of newly born buds, because there is not much nutrition to provide its growth. There can be no need to leave too many leaves on the branches, but there should be 1 Mel and 2 bud points.

We can soak the cut branches in rooting water for two hours, and then take them out to dry. In the process of rooting, we can choose the seedling box to operate, but if the branch is too large, we have to use a suitable flowerpot to plant.

When planting in the soil, you should first use chopsticks to poke a hole in the basin, and then put the branches in, do not directly use the branches to poke, this will easily cause blockage, which will directly affect its rooting. After all planting, spray the surface of the soil with a spray can, without watering too much water, and then keep it in a properly shaded place for maintenance.

If you insert leaves, choose some larger leaves, but not the ones with spots and scorched edges. The picked leaves should be put in a cool and ventilated place to dry, wait for the wound to heal a bit, put in the soil, so as to prevent the entry of bacteria.

After planting, we need to wait, after a period of time to observe, as long as its leaves are intact, it shows that the leaf insertion is very successful, kilowatts do not pull it out to check the rooting situation!