These three things are the most common to enable plant cuttings to take root quickly, and the second we use every day.

Cutting is a common method for the propagation of some flowers and plants, and it is a very successful thing to watch the success of their own flowers and plants cutting. However, it is difficult for some flowers and plants to take root when cutting, which makes some children's shoes lose confidence in cutting. Today, the little exquisite life will introduce two kinds of hair root artifacts, which will greatly improve the survival rate of cuttings after they take root.

I. Sponge

1. Find the discarded black sponge (white is OK, but black shading is good for the hair root), cut it into a square of 3 × 2 cm, then dig a hole in the middle of the square, and insert the cuttings to be cut into the hole in the sponge.

2. Put the cuttings and sponges in a plastic bottle with water about 2 centimeters high, and then put it in a ventilated place with scattered light.

3. You will see that the cuttings are rooted in about 20 days. Cut open the plastic bottle and put the cuttings on the pot together with the sponge. The survival rate is very high.

Paper towels

Camellia, triangular plum and other plant cuttings are not easy to take root, you can first use the method of high-altitude striping, with the help of paper towels to promote roots, and then the way of cutting to propagate. The specific operation methods are as follows:

1. first select the branches that need to be cut, peel about 1 centimeter with a beauty knife in the position to be cut off in the future, and then apply the rooting powder mixed with water with cotton swabs to the position of girdling.

2. Wrap two layers of paper towels to the position where the branches are peeled, wrap them with a layer of cling film and tie them tightly, then use a syringe to inject fresh water into the paper towels to make the paper towels moist. After the injection, a few small holes are pierced, and a layer of black plastic bag is placed on the outside to block the light.

3. About a month or so, the ring peeling place will take root, at this time the ring peeling place will be cut off the branches and cut into the pot.

III. Foam board

1. Insert some small holes in the foam board, insert the cuttings that need to be cut into the foam board from the hole, and expose the lower end of the cuttings through the foam board.

2. Put the foam board into the water container, and the foam board will float on the water surface.

3. You can pick up the foam board at any time and check it. After taking root, you can break the foam board and take out the cuttings and put them on the pot.

The above are three ways to let the cuttings take root quickly. If you hold it useful, you can try it yourself!