Methods and techniques for thickening branches of bonsai simple and easy to learn suggestions

The thickening of bonsai branches is a problem that many potted plants want to solve. Here, a quick way to loosen the subcutaneous tissue by loosening the trunk. Compared with other methods, this method is more convenient, convenient, fast and low cost.

one. Method of operation.

When the branch of the reserved point is found to be too thin, hold the root of the fulcrum with the index finger and thumb of the left hand to prevent the base from falling off and breaking, grasp the middle of the branch with the right hand, and then slowly swing the back, left and right side of the branch at a small angle in front. From small to large, it has swung to about 45 degrees at each angle, and each angle must be shaken seven to eight times in order to loosen local tissue, thus stimulating the unstable cortex and promoting the regeneration of plant cells. The growth of tissues and organs, as well as the growth of the whole, is based on the growth of cells. Cells practice through cell division, and increase the number and volume of cells by increasing the number of cells.

two. Operating time.

It should be determined that during the plant growing season, different plants need different growth temperatures. The suitable growth temperature of subtropical plants (such as elm, elm, Magnolia and pyracantha) is 25-35 ℃. We think that from April to September is the growing season for tree stumps in East China. This stage is the best operation period. It should be more appropriate in the morning or evening. Try to avoid the high temperature at noon.

Third, the number of operations.

For the parts of the branches after shaking and loosening, we should observe the roughness more frequently, each shaking interval should be about 10 days, and it will be operated again every ten days. When the appropriate roughness is reached, the shaking should be stopped immediately, otherwise it will cause excessive size and coarseness, the secondary branch and the primary branch are the same, and the local branch can be increased more than three times in the same year.

IV. matters needing attention

The diameter of the branch is too small, less than 0.3 cm in diameter. two. New buds are not suitable for operation before Lignification. three. Shake slowly and do not allow local bark to break. four. The branches that protect the branches prevent the emergence of buds during surgery. After each shaking, the valve stem must be fixed in time to create favorable conditions for the next molding.